Frequency Response

10 Questions MCQ Test Topicwise Question Bank for GATE Electronics Engineering | Frequency Response

This mock test of Frequency Response for Electronics and Communication Engineering (ECE) helps you for every Electronics and Communication Engineering (ECE) entrance exam. This contains 10 Multiple Choice Questions for Electronics and Communication Engineering (ECE) Frequency Response (mcq) to study with solutions a complete question bank. The solved questions answers in this Frequency Response quiz give you a good mix of easy questions and tough questions. Electronics and Communication Engineering (ECE) students definitely take this Frequency Response exercise for a better result in the exam. You can find other Frequency Response extra questions, long questions & short questions for Electronics and Communication Engineering (ECE) on EduRev as well by searching above.

The mid frequency gain of the amplifier circuit shown below with high value of beta of the BJT is


Applying KVL, we get: 


or, this diagram is CE unbypass amplifier so,


In a common source MOSFET amplifier circuit operating at 10 kH z, the drain resistance Rd = 200 kΩ. If MOSFET parameters are gm = 1.5 mA/V, r d = 50 kQ, Cds = 1.0 pF and Cgd = 2.0 pF, the voltage gain is equal to


An npn BJT has gm = 38 mΩ/V, Cμ = 10-14 F, Cπ = 4 x 10-13 F and DC current gain, β0 = 90. For this transistor fT and fβ are respectively




G iven for an FET, gm = - 9 .5 m A /volt, total capacitance = 500 pF. For a voltage gain of -30, the bandwidth will be


The drain gate capacitance of a junction FET is 2 pF. Assuming a common source voltage gain of 20, what is the input capacitance due to miller effect?


Assertion (A): In the high frequency model of FET, the voltage amplification drops drastically with increase in frequency.
Reason (R): The high frequency model is identical with the low frequency model except that the capacitances between various terminals (gate, source and drain) is added.


The high frequency mode! of FET is shown below.

Because of the internal capacitances (Cgd, Cgs and Cds), feedback exists between the output and input circuits of the FET in its high frequency model and hence the volta g e amplification drops drastically with the increase in frequency. Moreover, there is no feedback from output to input in the FET small signal (low frequency) model.
Flence, both assertion and reason are correct and reason is the correct explanation of assertion.


For a single stage CE amplifier, gm = 50 mA/V, Ce= 1 pF and Cc = 0.2 pF. The frequency at which the short circuit common-emitter current gain attains unit magnitude is given by


The frequency at which the short circuit common- emitter current gain attains unit magnitude is given by


When the load resistance is zero (short circuit) in a common-emitter configuration, the current flowing from the base to the collector node through the collector capacitor Cc, is small because


Ce can be as smai| as 1 pF, and Cc as small as 0.2 pF.
Thus, Cis larger than Cc


Consider the following statements:
1. For finding the transistor behaviour at high frequency it is necessary to examine the diffusion mechanism.
2. At low frequency it is assumed that the transistor responds instantly to changes of input voltage or current.
3. The hybrid-jr model is valid under dynamic conditions when the rate of change of \/BEis small enough so that the base incremental current/^ is small compared with the collector incremental current/^
4. The parameter fTis a frequency characteristic of a transistor.

Which of the above statements are correct?

  • The mechanism of the transport of charge carriers from emitter to collector is essentially one of diffusion. Hence, for finding the transistor behaviour at high frequency it is n e ce ssa ry to exam ine the d iffu sio n mechanism. Hence, statement-1 is correct.
  • Statement-2 is also correct.
  • Statement-3 is also correct.
  • The frequency at which the short-circuit common-emitter current gain attains unit magnitude is represented by fT Thus, Statement - 4 is also correct.

A modern bipolar transistor can have Ce = 1 pF. If gm = 50 mA/V, the fT of a common emitter amplifier will be



Similar Content

Related tests