1 Crore+ students have signed up on EduRev. Have you? 
DC average current of a bridge full wave rectifier (where I_{m} is the maximum peak current of input).
Average DC current of half wave rectifier is I_{m}. Since output of half wave rectifier contains only one half of the input. The average value is the half of the area of one half cycle of sine wave with peak I_{m}. This is equal to I_{m}.
DC power output of bridge full wave rectifier is equal to (I_{m} is the peak current and RL is the load resistance).
DC output power is the power output of the rectifier. We know V_{DC} for a bridge rectifier is 2V_{m} and I_{DC} for a bridge rectifier is 2I_{m}. We also know V_{DC}=I_{DC}/R_{L}. Hence output power is 4I_{m}^{2}R_{L}.
Ripple factor of a rectifier measures the ripples or AC content in the output. It’s obtained by dividing AC rms output with DC output. For full wave bridge rectifier it is 0.482.
If input frequency is 50Hz then ripple frequency of bridge full wave rectifier will be equal to_________
Since in the output of bridge rectifier one half cycle is repeated, the frequency will be twice as that of input frequency. So, f=100Hz.
Transformer utilization factor of bridge full wave rectifier _________
Transformer utilization factor is the ratio of AC power delivered to load to the DC power rating. This factor indicates effectiveness of transformer usage by rectifier. For bridge full wave rectifier it’s equal to 0.693.
If peak voltage on a bridge full wave rectifier circuit is 5V and diode cut in voltage os 0.7, then the peak inverse voltage on diode will be_________
PIV is the maximum reverse bias voltage that can be appeared across a diode in the circuit. If PIV rating of diode is less than this value breakdown of diode may occur.. Therefore, PIV rating of diode should be greater than PIV in the circuit, For bridge rectifier PIV is V_{m}V_{D} = 51.4=3.6.
It’s obtained by taking ratio of DC power output to maximum AC power delivered to load. Efficiency of a rectifier is the effectiveness of rectifier to convert AC to DC. It’s usually expressed inn percentage. For bridge full wave rectifier, it’s 81.2%.
In a bridge full wave rectifier, the input sine wave is 40sin100t. The average output voltage is_________
The equation of sine wave is in the form E_{m}sinωt.
Therefore, E_{m}=40. Hence output voltage is 2E_{m}=80V.
Number of diodes used in a full wave bridge rectifier is_________
The model of a bridge rectifier is same as Wein Bridge. It needs 4 resistors. Bridge rectifier needs 4 diodes while centre tap configuration requires only one.
In a bridge full wave rectifier, the input sine wave is 250sin100t. The output ripple frequency will be_________
The equation of sine wave is in the form of E_{m}sinωt. So, ω=100 and frequency (f)=ω/2=50Hz. Since output of bridge rectifier have double the frequency of input, f=100Hz.
11 videos57 docs97 tests

Use Code STAYHOME200 and get INR 200 additional OFF

Use Coupon Code 
11 videos57 docs97 tests






