Assuming that the signal is quantized to satisfy the condition of previous question and assuming the approximate bandwidth of the signal is W. The minimum required bandwidth for transmission of a binary PCM signal based on this quantization scheme will be
In PCM system, if the quantization levels are increased form 2 to 8, the relative bandwidth requirement will
1 Crore+ students have signed up on EduRev. Have you? Download the App |
A speech signal occupying the bandwidth of 300 Hz to 3 kHz is converted into PCM format for use in digital communication. If the sampling frequency is8 kHz and each sample is quantized into 256 levels, then the output bit the rate will be
Analog data having highest harmonic at 30 kHz generated by a sensor has been digitized using 6 level PCM. What will be the rate of digital signal generated?
Four voice signals. each limited to 4 kHz and sampled at Nyquist rate are converted into binary PCM signal using 256 quantization levels. The bit transmission rate for the time-division multiplexed signal will be
A TDM link has 20 signal channels and each channel is sampled 8000 times/sec. Each sample is represented by seven binary bits and contains an additional bit for synchronization. The total bit rate for the TDM link is
Four signals each band limited to 5 kHz are sampled at twice the Nyquist rate. The resulting PAM samples are transmitted over a single channel after time division multiplexing. The theoretical minimum transmissions bandwidth of the channel should be equal to
A sinusoidal massage signal m(t) is transmitted by binary PCM without compression. If the signal to-quantization-noise ratio is required to be at least 48 dB, the minimum number of bits per sample will be
A speech signal has a total duration of 20 sec. It is sampled at the rate of 8 kHz and then PCM encoded. The signal-to-quantization noise ratio is required to be 40 dB. The minimum storage capacity needed to accommodate this signal is
A linear delta modulator is designed to operate on speech signals limited to 3.4 kHz. The sampling rate is 10 time the Nyquist rate of the speech signal. The step size is 100 m V. The modulator is tested with a this test signal required to avoid slope overload is