Description

This mock test of Test: Turbulent Flow for Chemical Engineering helps you for every Chemical Engineering entrance exam.
This contains 10 Multiple Choice Questions for Chemical Engineering Test: Turbulent Flow (mcq) to study with solutions a complete question bank.
The solved questions answers in this Test: Turbulent Flow quiz give you a good mix of easy questions and tough questions. Chemical Engineering
students definitely take this Test: Turbulent Flow exercise for a better result in the exam. You can find other Test: Turbulent Flow extra questions,
long questions & short questions for Chemical Engineering on EduRev as well by searching above.

QUESTION: 1

Which of the following is true for turbulent flow?

Solution:

The product G _{r }P _{r} is often referred to as Rayleigh number, and its value sets the criterion of turbulent character of flow.

QUESTION: 2

Mc Adam relation is given by

Solution:

Here, n = 0.4 if the fluid is being heated.

QUESTION: 3

Investigate the effect of following condition on the average value of heat transfer coefficient in flow through a tube

Two fold increases in flow velocity by varying mass flow rate

It may be presumed that there is no change in the temperature of the liquid and the tube wall, and that the flow through the tube is turbulent in character

Solution:

h _{2}/h _{1 }= (V _{2}/V_{ 1}) ^{0.8} = .0741 = 74.1%

QUESTION: 4

Consider the above problem for two fold increase in the diameter of the tube, the flow velocity is maintained constant by change in the rate of liquid flow

Solution:

h _{2}/h _{1 }= (d _{1}/d_{ 2}) ^{0.2}.

QUESTION: 5

Calculate the rate of heat loss from a human body which may be considered as a vertical cylinder 30 cm in diameter, and 175 cm high while standing in a 30 km/hr wind at 15 degree Celsius. Human has a surface temperature of 35 degree Celsius

Solution:

Q = h A d t, h = Nu k/d.

QUESTION: 6

A heat treat steel plate measures 3 m by 1 m and is initially at 30 degree Celsius. It is cooled by blowing air parallel to 1 m edge at 9 km/hr. If the air is at 10 degree Celsius. Estimate the convection heat transfer from both sides of the plate

Solution:

Q = h A d t, h = Nu k/d.

QUESTION: 7

Consider the above problem, find the value of Reynolds number

Solution:

Re = p V l/µ = 16603

QUESTION: 8

The oil pan of 1.6 engine approximates a flat plate 0.3 m wide by 0.45 m long and protrudes below the framework of the automobile. The engine oil is at 95 degree Celsius and the ambient air temperature is 35 degree Celsius. If the automobile runs at 36 km/hr, make calculations for the rate of heat transfer from the oil-pan surface. Assume negligible resistance to conduction through the oil pan

Solution:

Q = h A d t, where h = (Nu) (k)/l and Nu = 0.664 (Re) ^{0.5} (Pr)^{.33}.

QUESTION: 9

Air flows through a 10 cm internal diameter tube at the rate of 75 kg/hr. Measurements indicate that at a particular point in the tube, the pressure and temperature of air are 1.5 bar and 325 K whilst the tube wall temperature is 375 K. Find heat transfer rate from one meter length in the region of this point

The general non-dimensional correlation for turbulent flow in the tube is

Nu = 0.023 (Re) ^{0.8} (Pr) ^{0.4}

Where the fluid properties are evaluated at the bulk temperature

Solution:

Q = h A d t, where h = (Nu) (k)/l = 177.35 W.

QUESTION: 10

Consider the above problem, find the value of Nusselt number

Solution:

Nu = 0.023 (Re) ^{0.8} (Pr) ^{0.4} = 40.46.

### Turbulent Flow

Doc | 1 Page

### Turbulent Flow

Doc | 1 Page

### Turbulent Flow

Doc | 1 Page

### Introduction - Turbulent Flow

Doc | 15 Pages

- Test: Turbulent Flow
Test | 10 questions | 10 min

- Test: Turbulent Flow - 2
Test | 9 questions | 30 min

- Test: Turbulent Flow - 1
Test | 10 questions | 30 min

- Test: Turbulent Flow in Pipes
Test | 9 questions | 30 min

- Test: Properties of Fluids & Turbulent Flow in Pipes - 2
Test | 30 questions | 90 min