Description

This mock test of Transportation And Assignment Model for Mechanical Engineering helps you for every Mechanical Engineering entrance exam.
This contains 10 Multiple Choice Questions for Mechanical Engineering Transportation And Assignment Model (mcq) to study with solutions a complete question bank.
The solved questions answers in this Transportation And Assignment Model quiz give you a good mix of easy questions and tough questions. Mechanical Engineering
students definitely take this Transportation And Assignment Model exercise for a better result in the exam. You can find other Transportation And Assignment Model extra questions,
long questions & short questions for Mechanical Engineering on EduRev as well by searching above.

QUESTION: 1

Which of the following is needed to use the transportation model?

Solution:

QUESTION: 2

Which method usually gives a very good solution to the assignment problem?

Solution:

QUESTION: 3

In applying Vogel’s approximation method to a profit maximation problem, row and column penalties are determined by

Solution:

The concept of Vogel’s Approximation Method can be well understood through an illustration given below :

The difference between two least cost cells are calculated for each row and column, which can be seen in the iteration given for each row and column.

QUESTION: 4

Which one of the following is riot the solution method of transportation method?

Solution:

QUESTION: 5

The matrix in assignment model is

Solution:

Assignment model can be solved by conventional linear programming approach or transportation model approach, it is square matrix, having equal number of rows and columns. The objective is to assign one item from row to one item from column so that total cost of assignement is minimum.

QUESTION: 6

In order for a transportation matrix which has six rows and four columns not to degenerate, what is the number of occupied cells, in the matrix?

Solution:

Number of cells for non-degenerate solution

= 6 + 4 - 1 = 9

QUESTION: 7

Consider the following statements:

1. For the application of optimally test in case of transportation model, the number of allocations should be equal to (m + n) where m is the number of rows and n is the number of columns.

2. Transportation problem is a special case of a linear programming problem.

3. In case of assignment problem, the first step is to dummy row or a matrix by adding a dummy row or a dummy column.

Which of these statements is/are correct?

Solution:

QUESTION: 8

Consider the following statements on transportation problem:

1. In Vogel’s approximation method, priority allotment is made in the cell with the lowest cost.

2. The North-west corner method ensures faster optimal solution.

3. If the total demand is higher than the supply, transportation problem cannot be solved.

4. A feasible solution may not be an optimal solution.

Which of these statements are correct?

Solution:

QUESTION: 9

Penalty cost method is

Solution:

QUESTION: 10

One disadvantage of using North-West Corner Rule to find initial solution to the transportation problem is that

Solution:

### 7 Transportation

Doc | 20 Pages

### Transportation System

Doc | 8 Pages

### Transportation in Plants

Doc | 5 Pages

- Transportation And Assignment Model
Test | 10 questions | 30 min

- Simplex Method And Transportation Model - MCQ Test 2
Test | 25 questions | 75 min

- Simplex Method And Transportation Model - MCQ Test 1
Test | 15 questions | 45 min

- Transportation Engineering 2
Test | 15 questions | 45 min

- Test: Transportation Introduction
Test | 10 questions | 20 min