Test: Civil Engineering (SSC JE) Technical- 10


100 Questions MCQ Test Mock test series of SSC JE Civil Engineering | Test: Civil Engineering (SSC JE) Technical- 10


Description
This mock test of Test: Civil Engineering (SSC JE) Technical- 10 for Civil Engineering (CE) helps you for every Civil Engineering (CE) entrance exam. This contains 100 Multiple Choice Questions for Civil Engineering (CE) Test: Civil Engineering (SSC JE) Technical- 10 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Civil Engineering (SSC JE) Technical- 10 quiz give you a good mix of easy questions and tough questions. Civil Engineering (CE) students definitely take this Test: Civil Engineering (SSC JE) Technical- 10 exercise for a better result in the exam. You can find other Test: Civil Engineering (SSC JE) Technical- 10 extra questions, long questions & short questions for Civil Engineering (CE) on EduRev as well by searching above.
QUESTION: 1

Match List-I with List-II and select the correct answer using the codes given below the lists:

Solution:
QUESTION: 2

Traps are used in household drainage systems to

Solution:
QUESTION: 3

Eutrophication of water bodies is caused by the

Solution:
QUESTION: 4

Zero hardness of water is achieved by

Solution:
QUESTION: 5

Sewage sickness occurs when

Solution:
QUESTION: 6

Self-purification of running streams may be due to

Solution:
QUESTION: 7

Which of the following is a weakness of bar chart

Solution:
QUESTION: 8

The time corresponding to minimum total project cost is

Solution:
QUESTION: 9

Uniformity coefficient of a soil is

Solution:
QUESTION: 10

A sample of soil has the following properties:

Liquid limit = 45%

Plastic limit = 25%

Shrinkage limit = 17%

Natural moisture content = 30%

The consistency index of the soil is

Solution:
QUESTION: 11

In a saturated soil deposit having a density of 22 kN/m3, the effective normal stress on ahorizontal plane at 5 m depth will be

Solution:
QUESTION: 12

The dry density of a soil is 1.5 g/cc. If the saturation water content were 50%, then itssaturated density and submerged density would, respectively, be

Solution:
QUESTION: 13

In standard penetration test, the splitspoon sampler is penetrated into the soil stratum by giving blows from a drop weight whose weight(in kg) and free fall (in cm) are, respectively

Solution:
QUESTION: 14

Fibre saturation point of timber is the moisture content in % when

Solution:
QUESTION: 15

According to the relevant I.S. code, the weight of the timber is to be reckoned at a

Solution:
QUESTION: 16

Bureau of Indian Standards classifies bitumen into grades 65/25, 85/40 etc. The first and second numbers respectively refer to

Solution:
QUESTION: 17

Surkhi is added to lime mortar to

Solution:
QUESTION: 18

Increase in fineness of cement

Solution:
QUESTION: 19

Consider the following statements:

The effect of air entrainment in concrete is to

1. increase resistance to freezing and thawing

2. improve workability

3. decrease strength

Which of these statements are correct

Solution:
QUESTION: 20

The beam ABC shown in Fig. is horizontal

The distance to the point of contraflexure from the fixed end 'A' is

Solution:
QUESTION: 21

The bending moment diagram of the beam shown in Fig. 10.55 is

Solution:
QUESTION: 22

A shaft turns at 150 rpm under a torque of 1500 Nm. Power transmitted is

Solution:
QUESTION: 23

For the compound bar whown in Fig. 10.61, the ratio of stresses in the portions AB : BC:
CD will be

Solution:
QUESTION: 24

A beam of square section 'a' is used with its diagonal horizontal. The modulus of section of
the beam is given by

Solution:
QUESTION: 25

Lug angles

Solution:
QUESTION: 26

For rivets in tension with counter-sunk heads, the tensile value shall be

Solution:
QUESTION: 27

Battens provided for a compression member shall be designed to carry a transverse shear equal to

Solution:
QUESTION: 28

Deep beams are designed for

Solution:
QUESTION: 29

Minimum clear cover (in mm) to the main steel bars in slab, beam, column and footing respectively are

Solution:
QUESTION: 30

In case of 2-way slab, the limiting deflection of the slab is

Solution:
QUESTION: 31

A reinforced concrete slab is 75 mm thick. The maximum size of reinforcement bar that can be used is

Solution:
QUESTION: 32

Drops are provided in flat slab to resist

Solution:
QUESTION: 33

In an RCC beam, side face reinforcement is provided if its depth exceeds

Solution:
QUESTION: 34

A doubly reinforced beam is considered less economical than a singly reinforced beam because

Solution:
QUESTION: 35

The ultimate strength of the steel used for prestressing is nearly

Solution:
QUESTION: 36

Water retentivity for brick masonry should not be less than

Solution:
QUESTION: 37

For a line AB

Solution:

QUESTION: 38

Local attraction in compass surveying may exist due to

Solution:
QUESTION: 39

A negative declination shows that the magnetic meridian is to the

Solution:
QUESTION: 40

The temporary adjustments of a prismatic compass are

(i) Centering

(ii) Levelling

(iii) Focusing the prism

The correct order is

Solution:
QUESTION: 41

The following consecutive readings were taken with a dumpy level:

0.695. 1.525, 2.395, 0.635, 0.605, 0.805,0.125

The instrument was shifted after the third andfifth readings. The readings 2.395 and 0.635 respectively represent

where F.S. is foresight, B.S. is backsight and I.S. is intermediate sight

Solution:
QUESTION: 42

Benchmark is established by

Solution:
QUESTION: 43

Agonic line is the line joining points having

Solution:
QUESTION: 44

Sodium Absorption Ratio (SAR) is defined as

Solution:
QUESTION: 45

A 70% index of wetness means

Solution:
QUESTION: 46

The major resisting force in a gravity dam is

Solution:
QUESTION: 47

The most suitable material for the central impervious core of a zoned embankment type dam is

Solution:
QUESTION: 48

The means of access for inspection and cleaning of sewer line is known as

Solution:
QUESTION: 49

What is the anchorage value of a standard hook of a reinforcement bar of diameter D

Solution:
QUESTION: 50

Which one of the following is the correct expression to estimate the development length of deformed reinforcing bar as per IS code in limit stage design

where Ø is diameter of reinforcing bar, σ s is the stress in the bar at a section and ζ bd is bond stress.

Solution:
QUESTION: 51

The cover of longitudinal reinforcing bar in a beam subjected to sea spray should not beless than which one of the following

Solution:
QUESTION: 52

What is the value of minimum reinforcement (in case of Fe 415) in a slab

Solution:
QUESTION: 53

What is the value of minimum reinforcement (in case of Fe 250) in a slab

Solution:
QUESTION: 54

The limits of percentage 'p' of the longitudinal reinforcement in a column is

Solution:
QUESTION: 55

What is the minimum number of longitudinal bars provided in a rainforced concrete columnof circular cross-section

Solution:
QUESTION: 56

Lateral ties in RC columns are provided to resist

Solution:
QUESTION: 57

The maximum strain in concrete at the outermost compression fiber in the limit state design offlexural member is (as per IS:456-1978)

Solution:
QUESTION: 58

The minimum strain at failure in the tensile reinforcement (Fy = 400 MPa) of RCC beamas per limit state method is

Solution:
QUESTION: 59

The wood preservative "Creosote " is derived from

Solution:
QUESTION: 60

Consider the following statements

:A good soil for making bricks should contain

1. about 30% alumina

2. about 10% lime nodules

3. a small quanitity of iron oxides

4. about 15% magnesia

Of these statement

Solution:
QUESTION: 61

The deformation per unit length is called

Solution:
QUESTION: 62

Hook's law holds good up to

Solution:
QUESTION: 63

The maximum stress produced in a bar of tapering section is at

Solution:
QUESTION: 64

A steel bar of 5 mm is heated from 15º C to 40ºC and it is free to expand. The bar willi nducce

Solution:
QUESTION: 65

Which of the following statement is correct ?

Solution:
QUESTION: 66

Stream lines and path lines always coincide in case of

Solution:

Solution:B

Stream Lines: Stream Line is an imaginary curve in a flow field such that tangent at any point on it represents the direction at instantaneous velocity vector at that point.

Path Line: Pathline is the actual path followed by an individual particle in a flow field over a period of time.

Streak Line: Streak Line is the locus of all fluid particles passing through a fixed point in a flow field at any instant of time.

For a steady flow, all three lines coincide with each other.

QUESTION: 67

The discharge through a cipolletti weir is given by

Solution:
QUESTION: 68

The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is

Solution:
QUESTION: 69

If there are n pipes of same diameter d laid in parallel in place of a single pipe of diameter D

, then (assume same discharge flowing in each new pipe as old one)

Solution:

hL will be same for both the cases

flQ2 / 12.1 D2 = (n)  ( flQ / 12.1 d2 )

QUESTION: 70

The critical state of flow through a channel section may be defined as the state of flow at which the

Solution:
QUESTION: 71

The value of Froude number can be

Solution:
QUESTION: 72

When the bubble of the level tube of a level remains central

Solution:
QUESTION: 73

In limit state design of concrete for flexure, the area of stress block is taken as

Solution:
QUESTION: 74

Stress strain curve of concrete is

Solution:
QUESTION: 75

In moment distribution method, the sum of distribution factors of all the members meeting at any joint is always

Solution:
QUESTION: 76

While calculating the sight distances, the driver's eye above road surface is assumed as

Solution:
QUESTION: 77

The characteristics of fresh and septic sewage respectively are

Solution:
QUESTION: 78

Strength of concrete increases with

Solution:
QUESTION: 79

Inner part of a timber log surrounding the pitch, is called

Solution:
QUESTION: 80

The type of brick masonery bond in which every course contains both headers and stretchers, is called

Solution:
QUESTION: 81

Degree of kinematic indeterminacy of a pin jointed plane frame is given by

Solution:
QUESTION: 82

A cohesive soil yield a maximum dry density of 18kN/m3 during a standard ProctorCompaction test.If the specific gravity is 2.65, what would be its void ratio ?

Solution:
QUESTION: 83

Effective stress on soil

Solution:
QUESTION: 84

The ratio of curvature provided along atransition curve, is

Solution:
QUESTION: 85

The individual variation between test strength of concrete cube sample should not be more than

Solution:
QUESTION: 86

The ratio of maximum shear stress to average shear of a beam circular in cross-section , is

Solution:
QUESTION: 87

Match List-I (Propoerties) with List-II (Stress points labelled 1, 12, 3 and 4) and select the correct answer using the codes given below the lists:
 

List-I
a. Yield point
b. Proportional limit
c. Rupture strength
d. Ultimate strength

Solution:
QUESTION: 88

Match List-I (Failure Mode) with List-II (Reason) and select the correct answer using the codes given below the lists:

List-I (Failuren mode)
a. Shear failure of plates
b. Bearing failure of plates
c. Tearing failure of plates
d. Splitting failure of plates

List-II (Reason)
1. Insufficient edge distance
2. Strength of plate is less than that of the rivets

Solution:
QUESTION: 89

Which one of the following is the chronological sequence is regard to road construction/developement ?

Solution:
QUESTION: 90

In cement concrete pavements, tie bars are installed in

Solution:
QUESTION: 91

In a Mohr's circle of  plane (σ– normal stress, σ = shear stress), the vertical diameter represents

Solution:
QUESTION: 92

One true colour unit is colour produced by

Solution:
QUESTION: 93

Most commonly adopted pumps in water supplies are

Solution:
QUESTION: 94

With usual notations, Stokes' law for velocity of setting of soil on still water is

Solution:
QUESTION: 95

If h1 is total hydraulic head, Nf is total number of flow channels and Nd is total number of potential drops in a flow net, then seepage flow rate is given by

Solution:
QUESTION: 96

The consolidatio settlement is given by the expression

Solution:
QUESTION: 97

Thermal stratification of impounded water is in the order

Solution:
QUESTION: 98

Temperature of water more than ______ is considered objectionable

Solution:
QUESTION: 99

Aerobic method of composting practised in India is called

Solution:
QUESTION: 100

In a linear reservior , the

Solution: