Test: Civil Engineering (SSC JE) Technical- 6


100 Questions MCQ Test Mock test series of SSC JE Civil Engineering | Test: Civil Engineering (SSC JE) Technical- 6


Description
This mock test of Test: Civil Engineering (SSC JE) Technical- 6 for Civil Engineering (CE) helps you for every Civil Engineering (CE) entrance exam. This contains 100 Multiple Choice Questions for Civil Engineering (CE) Test: Civil Engineering (SSC JE) Technical- 6 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Civil Engineering (SSC JE) Technical- 6 quiz give you a good mix of easy questions and tough questions. Civil Engineering (CE) students definitely take this Test: Civil Engineering (SSC JE) Technical- 6 exercise for a better result in the exam. You can find other Test: Civil Engineering (SSC JE) Technical- 6 extra questions, long questions & short questions for Civil Engineering (CE) on EduRev as well by searching above.
QUESTION: 1

Pick up the correct statement from the following:Method of sawing timber

Solution:
QUESTION: 2

Based on its dry weight, a freshly felled tree maycontain water upto

Solution:
QUESTION: 3

A well seasoned timber may contain moisture up to

Solution:
QUESTION: 4

The pigment used in paints for corrosive resistance, is

Solution:
QUESTION: 5

The steel used for rails under heavy traffic and on sharp curves, is

Solution:
QUESTION: 6

Dorry's testing machine is used for

Solution:
QUESTION: 7

For a good building stone, its specific gravity should the greater than

Solution:
QUESTION: 8

Match List-I with List-II and select a suitable answer by using the codes given below the lists:

Solution:
QUESTION: 9

The 9cm ×9 cm side of a brick as seen in thewall face, is generally known as

Solution:
QUESTION: 10

The portion of a brick cut across the width, is called

Solution:
QUESTION: 11

Cavity wall is generally provided for

Solution:
QUESTION: 12

The type of bond in which every course contains both headers and stretchers, is called

Solution:
QUESTION: 13

The type of bond in a brick masonry containing alternate courses of stretchers and headers, is called

Solution:
QUESTION: 14

 The following operations refer to the preparation of clay:

1. Weathering

2. Tempering

3. Cleaning

4. Blending

Their correct sequence is :

Solution:
QUESTION: 15

Greater accuracy in linear measurements, is obtained by

Solution:
QUESTION: 16

Cross hair in surveying telescopes, are fitted

Solution:
QUESTION: 17

In setting up a plane table at any station

Solution:
QUESTION: 18

Plotting of inaccessible points on a plane table,is done by

Solution:
QUESTION: 19

One of the Lehmann's rules of plane tabling, is

Solution:
QUESTION: 20

Imaginary line passing through points having equal magnetic declination is termed as

Solution:
QUESTION: 21

Match list I with List II and select the correct answer by using the codes given below the lists:

Solution:
QUESTION: 22

According to Unwin's formula, the diameter d of a rivet of plate of thickness t is :

Solution:
QUESTION: 23

The weakest section of a diamond riveting, is the section which passes through

Solution:
QUESTION: 24

Maximum deflection of a centilever due to pure bending moment M at its free end, is

Solution:
QUESTION: 25

Match List-I with List-II and select a correct answer by using the codes given below to lists:

 

Solution:
QUESTION: 26

The shape of the bending moment diagram over the length of a beam, having no external load. is always

Solution:
QUESTION: 27

The effect of arching a beam, is

Solution:
QUESTION: 28

A three-hinged arch is said to be:

Solution:
QUESTION: 29

The shear stress at any section of a shaft ismaximum

Solution:
QUESTION: 30

In a loaded beam, the point of contraflexture occurs at a section where

Solution:
QUESTION: 31

The bending moment at C of a portal frame shown in figure is

Solution:
QUESTION: 32

Match List-I with List-II and select a correct answer by using the codes given below to lists:

Solution:
QUESTION: 33

For the two dimensional flow, the stream functionis given by ψ =2xy. The velocity at a point (3,4) is

Solution:
QUESTION: 34

Euler's equation for motion of liquids, is given by

Solution:
QUESTION: 35

For solving network problem of pipes, necessary condition is

Solution:
QUESTION: 36

If k is the radius of gyration, h the metacentric height, g the acceleration due to gravity, the time
of oscillation of a floating body, is

Solution:
QUESTION: 37

The time required to close a valve gradually is

Solution:
QUESTION: 38

Match List-I with List-II and select a correct answer by using the codes given below to lists:

Solution:
QUESTION: 39

The best side slope for most economical trapezoidal section, is

Solution:
QUESTION: 40

If   pressure gradient, r = radius at any point, R is radius of the pipe, and Umax is central line velocity , m is average velocity, μ. is coefficient of viscosity and D is diameter of the pipe, then match List-I with List-II and choose the correct

Solution:
QUESTION: 41

Match List-I with List-II and select a correct answer by using the codes given below to lists:

Solution:
QUESTION: 42

The pipe mains carrying water from the source to the reservoir are designed for the

Solution:
QUESTION: 43

The per capita water demand include

Solution:
QUESTION: 44

The “distribution mains” are designed for

Solution:
QUESTION: 45

Match the columns most appropriately :
Water pipe material                 Average age of pipe
a. Cast iron                                1. 75 years
b. Steel                                       2. 100 years
c. R.C.C.                                    3. 40 years

Solution:
QUESTION: 46

Consider the following statements :
The basic difference between water pipes and sewer pipes is
1. in the material used for the pipes
2. in the pressure of the liquid flow
3. in the suspended solids they carry
Which of these statements is/are correct ?

Solution:
QUESTION: 47

A commonly used handpump is the

Solution:
QUESTION: 48

The threshold odour number (TON) for a water sample of 40 ml, dilute to standard 200 mlmixture, in which odour is just barely detectable to the sense of smell, is

Solution:
QUESTION: 49

Water is considered ‘hard’, if its hardness is of the order of

Solution:
QUESTION: 50

Match List-I (Water-born disease) with List- II (Pollution causing) and select the correct
answer using the codes given below the lists :

Solution:
QUESTION: 51

The temporary hardness of water is caused by

Solution:
QUESTION: 52

Total Kjeldahi nitrogen is a measure of

Solution:
QUESTION: 53

Match List-I (Distribution system) with List-II (Characteristics) and select the correct answer
using the codes given below the lists :

List-I
a. Tree system
b. Grid-iron or reticulation system
c. Circular system
d. Radial system
 

List-II
1. Main lines are laid along the periphery covering the entire area
2. Calculations are simple and accurate flow determination is also possible at any line
3. Large number of cut-off valve and longer pipe lengths are required
4. Flow from centre to periphery

 

Solution:
QUESTION: 54

The low velocity in sewer pipe may cause

Solution:
QUESTION: 55

The pH of fresh sewage is usually

Solution:
QUESTION: 56

Match List-I (Type of waste) with List-II (Description) and select the correct answer using
the codes given below the lists :

List-I
a. Refuse
b. Sullage
c. Sewage
d. Rubbish
List-II
1. Wastes of combustible nature
2. Waste water with higher decomposable fraction
3. All kinds of wastes
4. Waste water with low biodegradable fraction

Solution:
QUESTION: 57

Which of the following is a weakness of bar chart?

Solution:
QUESTION: 58

The process of incorporating changes and rescheduling or replanning is called

Solution:
QUESTION: 59

The basic action involved in sheep foot rolling is

Solution:
QUESTION: 60

Batching refers to

Solution:
QUESTION: 61

A reinforced concrete slab is 75 mm thick. The maximum size of reinforced bar that can be usedis of

Solution:
QUESTION: 62

In case of simply supported beam, the clear distance between lateral restrains shall not exceed

Solution:
QUESTION: 63

In case of 2-way slab, the limiting deflection of the slab is

Solution:
QUESTION: 64

A reinforced concrete member is subjected tocombined action of combined action ofcompressive axial force and bending moment. If ∈cis the best least compressive strain in themember, fy, the yield stress of steel and, Es, themodulus of elasticity of steel, the maximum permissible compressive strain in concrete member will be

Solution:
QUESTION: 65

Minimum clear cover (in mm) to the main steel bars in slab, beam, column and footing respectively are

Solution:
QUESTION: 66

If the depth of actual neutral axis in a beam is more than the depth of critical neutral axis, thebeam is called:

Solution:
QUESTION: 67

The minimum reinforced using mild steel in slab should not be less than.

Solution:
QUESTION: 68

The average permissible stress in bond for plainbars in tension is

Solution:
QUESTION: 69

Critical section for shear is case of flat slabs is ata distance of

Solution:
QUESTION: 70

The diagonal tension whcih results in ultimate failure due to development of diagonal tension cracks, depends on

Solution:
QUESTION: 71

Which one of the following is the correct expression to estimate the development length
of deformed reinforcing bar as per IS code in limit state design?

Solution:

QUESTION: 72

What is the anchorage value of a standard hook of reinforcement bar of diameter D?

Solution:
QUESTION: 73

The bond strength between steel and concrete is due to

Solution:
QUESTION: 74

Which one of the following is the mode of failure in a fillet weld material ?

Solution:
QUESTION: 75

If 20 mm rivets are used in lacing bars, then the minimum width of lacing bar should be

Solution:
QUESTION: 76

In a gusseted base, when the end of the column is machined for completer bearing on the baseplate, the axial load i sassumed to be transferred to the base plate

Solution:
QUESTION: 77

Gusset plate is provided in column base connection to

Solution:
QUESTION: 78

The web crippling due to excessive bearing stress can be avoided by

Solution:
QUESTION: 79

Intermediate vertical stiffeners are provided in plate girders to

Solution:
QUESTION: 80

The maximum permissible deflection for gantry girder of span 6m on which an EOT crane o of capacity 200 kN is operating is

Solution:
QUESTION: 81

Normally, the angle of roof truss with asbestos sheets should not be less than

Solution:
QUESTION: 82

Arrange the following cross-section in the increasing order of their respective shape factors

Solution:
QUESTION: 83

The traffic manoeuvre shown in fig. represents

Solution:
QUESTION: 84

Equivalent factor of passenger car unit (PCU) for a passenger car as per IRC is

Solution:
QUESTION: 85

The background colour of the informatory sign baord is

Solution:
QUESTION: 86

Which of the following is indicated by a warning sign ?

Solution:
QUESTION: 87

The critical combination of stresses for corner region in cement concrete roads is

Solution:
QUESTION: 88

The function of an expansion joint in rigid pavements is to

Solution:
QUESTION: 89

At liquid limit, all soils possess

Solution:
QUESTION: 90

When a soil sample is subjected to a uniformly distributed fluid pressure only, in a triaxial
compression test, the Mohr's representation of the state of stress on sample is

Solution:
QUESTION: 91

Sensitivity of a soil can be defined as

Solution:
QUESTION: 92

When the degree of consolidation is 50% the time factor is about

Solution:
QUESTION: 93

A rectangular footing LxB is to be placed at a depth D below ground level such that D/B < 2.5. The factor NC to be used in deciding on the allowable bearing capacity for the footing as given by Skempton is calculated using the equation (where R NC = NC for rectangular footing, S NC = NC at surface)

Solution:
QUESTION: 94

Permissible settlement is relatively higher for

Solution:
QUESTION: 95

A raingauge should preferably be fixed

Solution:
QUESTION: 96

A flownet is drawn to obtain

Solution:
QUESTION: 97

A dry sand specimen is put through a triaxial test.The cell pressure is 50 kPa and the deviator stressat failure is 100 kPa. The angle of internal frictionfor the sand specimen is

Solution:
QUESTION: 98

Ringelmenn's scale is used to

Solution:
QUESTION: 99

Optimum depth of kor watering for rice is

Solution:
QUESTION: 100

Figures given below indicate the weights of different pycnometers.

Solution: