The temperature coefficient of resistance of a wire is 0.00125 per °C. At 300 K, its resistance is 1 ohm. This resistance of the wire will be 2 ohm at.
A constant voltage is applied between the two ends of a uniform metallic wire. Some heat is developed in it. The heat developed is doubled if
KEY CONCEPT : The heat produced is given by
Thus heat (H) is doubled if both length (l) and radius (r) are doubled.
The electrostatic field due to a point charge depends on the distance r as 1/r^{2} . Indicate which of the following quantities shows same dependence on r.
In the circuit shown in fig the heat produced in the 5 ohm resistor due to the current flowing through it is 10 calories per second.
The heat generated in the 4 ohms resistor is
Since R_{AB} = 2R_{CD} therefore, current in AB will be half as compared to current in CD.
Here P_{4} = Power dissipation in 4Ω
P_{5} = Power dissipation in 5Ω
The current i in the circuit (see Fig) is
BC and AC are in series
Now BA and DC are in parallel.
A piece of copper and another of germanium are cooled from room temperature to 80° K. The resistance of
Copper is a metal whereas Germanium is Semiconductor.
NOTE : Resistance of metal decreases and semiconductor increases with decrease in temperature.
A battery of internal resistance 4Ω is connected to the network of resistances as shown. In order that the maximum power can be delivered to the network, the value of R in Ω should be
The equivalent circuits are shown in the figure.
The circuit represents balanced Wheatstone Bridge.
Hence 6R Ω resistance is ineffective
For Max. Power External Resistance = Internal Resistance 2R = 4 Ω ∴ R = 2Ω
In the circuit P≠R , the reading of the galvanometer is same with switch S open or closed. Then
Since the opening or closing the switch does not affect the current through G, it means that in both the cases there is no current passing through S. Thus potential at A is equal to potential at B and it is the case of balanced wheatstone bridge..
I_{P} = I_{Q} and I_{R} = I_{G}
In the given circuit, with steady current, the potential drop across the capacitor must be
There will be no current flowing in branch BE in steady condition.
Let I be the current flowing in the loop ABCDEFA.
Applying Kirchoff's law in the loop moving in anticlockwise direction starting from C. + 2V – I (2R) – I (R) – V = 0
∴V = 3IR
⇒ I = V/3R ... (1)
Applying Kirchoff's law in the circuit ABEFA we get on moving in anticlockwise direction starting from B
+ V + Vcap – IR – V = 0 (where Vcap is the p.d. across capacitor).
A wire of length L and 3 identical cells of negligible internal resistances are connected in series. Due to the current, the temperature of the wire is raised by ΔT in a time t. A number N of similar cells is now connected in series with a wire of the same material and crosssection but of length 2L. The temperature of the wire is raised by the same amount ΔT in the same time t. the value of N is
Let R be the resistance of wire.
Energy released in t second
Let R' be the resistance of the second wire
Dividing (i) by (ii)
or, N^{ 2} = 18 × 2 ∴ N = 6
In the given circuit, it is observed that the current I is independent of the value of the resistance R_{6}. Then the resistance values must satisfy
Since current I is independent of R6, it follows that the resistance R_{1}, R_{2}, R_{3} and R_{4} must form the balanced Wheatstone bridge.∴ R_{1} R_{4} = R_{2}R_{3}
The effective resistance between points P and Q of the electrical circuit shown in the figure is
The circuit is symmetrical about the axis POQ.
The circuit above the axis POQ represents balanced wheatstone bride. Hence the central resistance 2R is ineffective. Similarly in the lower part (below the axis POQ) the central resistance 2R is ineffective.
Therefore the equivalent circuit is drawn.
A 100 W bulb B_{1}, and two 60 W bulb B_{2} an d B_{3}, are connected to a 250 V source, as shown in figure. Now W_{1}, W_{2} and W_{3} are the output powers of the bulbs B_{1}, B_{2} and B_{3}, respectively. Then
Express which of the following set ups can be used to verify Ohm’s law?
In ohm's law, we check V = IR where I is the current flowing through a resistor and V is the potential difference across that resistor. Only option (a) fits the above criteria.
NOTE : Remember that ammeter is connected in series with resistance and voltmeter parallel with the net resistance.
In the shown arrangement of the experiment of the meter bridge if AC corresponding to null deflection of galvanometer is x, what would be its value if the radius of the wire AB is doubled?
At null point
If radius of the wire is doubled, then the resistance of AC will change and also the resistance of CB will change. But since R_{1}/R_{2 }does not change so, R_{3}/R_{4}
should also not change at null point. Therefore the point C does not change.
The three resistance of equal value are arranged in the different combinations shown below. Arrange them in increasing order of power dissipation.
III < II < IV < I.
Shown in figure is a Post Office box. In order to calculate the value of external resistance, it should be connected between
Total external resistance will be the total resistance of whole length of box. It should be connected between A and D.
Six identical resistors are connected as shown in the figure.The equivalent resistance will be
For var ious combination s equivalent r esistan ce is maximum between P and Q.
A capacitor is charged using an exter nal batter y with a resistance x in series. The dashed line shows the variation of ln I with respect to time. If the resistance is changed to 2x, the new graph will be
KEY CONCEPT : The current in RC circuit is given by I = I_{0}e^{–t/RC}
On comparing with y = mx + C
When R is changed to 2R then slope increases and current becomes less. New graph is Q.
Find out the value of current through 2Ω resistance for the given circuit.
The current in 2W resistor will be zero because it is not a part of any closed loop.
A 4 μF capacitor, a resistance of 2.5 MΩ is in series with 12 V battery. Find the time after which the potential difference across the capacitor is 3 times the potential difference across the resistor. [Given ln(2) = 0.693]
KEY CONCEPT : At any instant of time t during charging process, the transient current in the circuit is given by
∴ Potential difference across resistor R is
∴ Potential diff. across C
A moving coil galvanometer of resistance 100 Ω is used as an ammeter using a resistance 0.1 Ω. The maximum deflection current in the galvanometer is 100 μA. Find the minimum current in the circuit so that the ammeter shows maximum deflection
KEY CONCEPT :
I_{g}G = (I – I_{g}) S
An ideal gas is filled in a closed rigid and thermally insulated container. A coil of 100 Ω resistor carrying current 1 A for 5 minutes supplies heat to the gas. The change in internal energy of the gas is
The heat supplied under these conditions is the change in internal energy Q = ΔU
The heat supplied Q = i^{2}RT = 1 × 1 × 100 × 5 × 60 = 30,000 J = 30 kJ
If a steady current I is flowing through a cylindrical element ABC. Choose the correct relationship
A resistance of 2Ω is connected across one gap of a metrebridge (the length of the wire is 100 cm) and an unknown resistance, greater than 2Ω, is connected across the other gap. When these resistances are interchanged, the balance point shifts by 20 cm. Neglecting any corrections, the unknown resistance is
Given X is greater than 2Ω when the bridge is balanced
When the resistances are interchanged the jockey shifts 20 cm. Therefore
A circuit is connected as shown in the figure with the switch S open. When the switch is closed, the total amount of charge that flows from Y to X is
The total charge enclosed in the dotted portion when the switch S is open is zero. When the switch is closed and steady state is reached, the current I coming from the battery is 9 = I (3 + 6) ⇒ I = 1A
∴ Potential difference across 3Ω resistance = 3V and potential difference across 6Ω resistance = 6V
∴ p.d. across 3 µF capacitor = 3V an d p.d. across 6 µF capacitor = 6V
∴ Charge on 3 µF capacitor Q1 = 3 × 3 = 9 µC Charge on 6 µF capacitor Q2 = 6 × 6 = 36 µC The total charge enclosed in the dotted portion =
∴ Charge passing the switch = 36 – 9 = 27 µC
Figure shows three resistor configurations R_{1}, R_{2} and R_{3} connected to 3V battery. If the power dissipated by the configuration R_{1}, R_{2} and R_{3}, is P_{1}, P_{2} and P_{3}, respectively, then –
We know that
P=We know that
P=V^{2}/R
For constant value of potential difference (V) we have
For constant value of potential difference (V) we have
This is a case of balanced Wheatstone bridge R1 = 1Ω Case (ii)
Clearly the equivalent resistance (R2) will be less than 1Ω.
Case (iii)
Since, R_{2} < R_{1} < R_{3}
∴ P_{2} > P_{1} > P_{3}
Incandescent bulbs are designed by keeping in mind that the resistance of their filament increases with the increase in temperature. If at room temperature, 100 W, 60 W and 40 W bulbs have filament resistances R_{100}, R_{60} and R_{40}, respectively, the relation between these resistances is
We know that P=V^{2}/R
For a given potential difference at a particular temperature
It is given that the powers of the bulbs are in the order
100W > 60 W > 40W
To verify Ohm’s law, a student is provided with a test resistor R_{T}, a high resistance R_{1}, a small resistance R_{2}, two identical galvanometers G_{1} and G_{2}, and a variable voltage source V. The correct circuit to carry out the experiment is
c) The following points should be considered while making the circuit :
(i) An ammeter is made by connecting a low resistance R_{2} in parallel with the galvanometer G_{2}.
(ii) A voltmeter is made by connecting a high resistance R_{1 }in series with the galvanometer G_{1}.
(iii) Voltmeter is connected in parallel with the test resistor R_{T}.
iv) Ammeter is connected in series with the test resistor RT.
(v) A variable voltage source V is connected in series with the test resistor R_{T}.
Consider a thin square sheet of side L and thickness t, made of a material of resistivity ρ. The resistance between two opposite faces, shown by the shaded areas in the figure is
We know that R=ρ l/a
Where l is the length of the conductor through which the current flows and a is the area of cross section.
Here l = L and a = L × t
∴ R is independent of L
A meter bridge is set up as shown, to determine an unknown resistance ‘X’ using a standard 10 ohm resistor. The galvanometer shows null point when tappingkey is at 52 cm mark. The endcorrections are 1 cm and 2 cm respectively for the ends A and B. The determined value of ‘X’ is
At Null point
Here l_{1} = 52 + End correction = 52 + 1 = 53 cm
l_{2} = 48 + End correction = 48 + 2 = 50 cm
During an experiment with a metre bridge, the galvanometer shows a null point when the jockey is pressed at 40.0 cm using a standard resistance of 90 Ω, as shown in the figure. The least count of the scale used in the metre bridge is 1mm. The unknown resistance is
In case of a meter bridge
For finding the value of R
For finding the value of ΔR
Therefore, R = (60 ± 0.25)Ω
An infinite line charge of uniform electric charge density λ lies along the axis of an electrically conducting infinite cylindrical shell of radius R. At time t = 0, the space inside the cylinder is filled with a material of permittivity ε and electrical conductivity σ. The electrical conduction in the material follows Ohm's law. Which one of the following graphs best describes the subsequent variation of the magnitude of current density j(t) at any point in the material?
From (i), (ii), and (iii)
Here negative sign signifies that the current is decreasing
From (v) and (vi)
On integrating
Substituting this value in (iv) we get
Use Code STAYHOME200 and get INR 200 additional OFF

Use Coupon Code 






