Courses

Test: Hydraulic Pump - 1

10 Questions MCQ Test Topicwise Question Bank for Mechanical Engineering | Test: Hydraulic Pump - 1

Description
This mock test of Test: Hydraulic Pump - 1 for Mechanical Engineering helps you for every Mechanical Engineering entrance exam. This contains 10 Multiple Choice Questions for Mechanical Engineering Test: Hydraulic Pump - 1 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Hydraulic Pump - 1 quiz give you a good mix of easy questions and tough questions. Mechanical Engineering students definitely take this Test: Hydraulic Pump - 1 exercise for a better result in the exam. You can find other Test: Hydraulic Pump - 1 extra questions, long questions & short questions for Mechanical Engineering on EduRev as well by searching above.
QUESTION: 1

Solution:

QUESTION: 2

Solution:
QUESTION: 3

If D is the diameter of impeller at inlet, B is the width of impeller at inlet and Vf the velocity of flow at inlet, then discharge through a centrifugal pump is equal to

Solution:

QUESTION: 4

Centrifugal pump is started with its delivery valve

Solution:
QUESTION: 5

When a piping system is made up primarily of vertical lift and very little pipe friction, the pump characteristics should be

Solution:
QUESTION: 6

Typical range of specific speeds for axial flow pumps is

Solution:

QUESTION: 7

In a centrifugal pump the inlet angle will be designed to have

Solution:

QUESTION: 8

The specific speed of a pumps has the dimensions of

Solution:
QUESTION: 9

A centrifugal pump has outer and inner diameters of 0.3 m and 0.15 m respectively. When running at 1800 rpm, with the discharge pipe completely shut off, the head produced is
[Take 0 = 1 0 m/s2]

Solution:

QUESTION: 10

If two pumps identical in all respects and each capable of delivery a discharge Q against a head Hare connected in parallel, the resulsting discharge is

Solution: