Which of the following forces are measured directly by strain gauges or force dynamometers during metal cutting?
1. Force exerted by the tool on the chip acting - normally to tool face.
2. Horizontal cutting force exerted by the tool on the workpiece.
3. Frictional resistance of the tool against the chip flow acting along the tool face.
4. Vertical force which helps in holding the tool in position.
The type of wear that occurs due to the cutting action of the particles in the cutting fluid is referred to as
Consider the following tool materials:
1. High speed steel
2. High carbon steel
3. Cemented carbides
Q. Negative rake angle is provided for
The coefficient of friction in metal cutting varies between
The main source of heat generation in metal cutting is
During machining, the wear land (h) has been plotted against machining time (T) as given in the following figure.
Q. For a critical wear land of 1.8 mm, the cutting tool life (in minute) is
Diamond cutting tools are not recommended for machining of ferrous metals due to
Inclination angle of a turning tool is measured on its
A cutting too! can never have its
Inconel and Haste alloy require cutting tools that are
High tungsten content in a carbide tool will
Tool signature is
Tool signature/tool designation is a convenient way to describe the tool angles by using the standardized abbreviated system
Consider the following characteristics:
1. The cutting edge is normal to the cutting velocity.
2. The cutting forces occurs in two direction only.
3. The cutting edge is wider than the depth of cut.
The characteristics applicable to orthogonal cutting would include
In orthogonal cutting, cutting face of the tool is 90° to the line of action or path of the tool.
Shop is confined mainly to such operations as knife turning, broaching and slotting the bulk of machining being done by oblique cutting.
In oblique cutting of metals, the cutting edge of tool is
If the cutting face is inclined at an angle less than 90° to the path of the tool, the cutting action is known as oblique.
The portion of tool on which cutting edge is formed is known as
Shank is called man body of cutting tool in which cutting edge is formed.
Tool signature in ASA system comprises of
Tool signature consists of 6 angles and one nose radius hence 7 elements.
Tool signature in ASA system, the nose radius is indicated in
Angle between the face and flank of the single point cutting tool is known as
The angle between the face of the tool and the plane parallel to the base of the cutting tool is called
The angle on which the strength of the tool depends is
Higher the positive back rake angle, tool becomes weaker and tools having negative back rake angle are very strong.
Shear angle is the angle between
A blind hole is better tapped with a tap having
Nose radius is expressed in
Nose radius is expressed in mm.
When machining a hard and brittle metal like cast iron, the type of chips produced is
Discontinuous chips are formed when machining brittle material at iow speed.
Single point thread cutting tool should ideally have
The function of chip-breaker in a cutting tool is
A continuous type of chip is quite troublesome, they should be broken into comparatively small pieces for the ease of handling and to prevent it from becoming a work hazard, hence chip breakers are used to reduce the swarf into small pieces as they are formed.
An ideal tool material is the one which
In metal cutting operation, the approximate ratio of heat distributed among chip, tool and work in that order is
Maximum heat is carried away be chip, i.e., 80% of the total heat generated is carried away by the chip.
Which of the following is the correct relationship between the shear angle φ, friction angle β and cutting rake angle α given by Merchant analysis is
Which of the following relationship between shear angle φ, friction angle β and cutting rake angle α is known as lee and shatter analysis
Lee and shaffer analysis is given by