Description

This mock test of Beams - 2 for Civil Engineering (CE) helps you for every Civil Engineering (CE) entrance exam.
This contains 9 Multiple Choice Questions for Civil Engineering (CE) Beams - 2 (mcq) to study with solutions a complete question bank.
The solved questions answers in this Beams - 2 quiz give you a good mix of easy questions and tough questions. Civil Engineering (CE)
students definitely take this Beams - 2 exercise for a better result in the exam. You can find other Beams - 2 extra questions,
long questions & short questions for Civil Engineering (CE) on EduRev as well by searching above.

QUESTION: 1

The rolled steel section used in a cased beam has width ‘B’ mm and depth ‘D’ mm. The minimum width in mm of the finished cased beam is given by

Solution:

QUESTION: 2

Lateral buckling of beam starts from top flange because of

Solution:

QUESTION: 3

For a cantilever beam of length L built-in at the support and restrained against torsion at the free end, the effective projecting length l is

Solution:

QUESTION: 4

If ends are assumed to be fixed, then slenderness ratio for web buckling and diagonal buckling respectively is

where

d = clear depth of web between roots of fillet

t = web thickness

Solution:

QUESTION: 5

Under a concentrated load, bearing stress f_{b} in a beam, is given by

Solution:

QUESTION: 6

In web crippling, the bearing length under reactions at the support is calculated by

where

b = width of the bearing plate

h = depth of root of the fillet in mm

Solution:

QUESTION: 7

The area A_{p} of cover plates in one flange of a built up beam, is given by

Solution:

QUESTION: 8

In a simply supported beam of span l, each end is restrained against torsion, compression flange being unrestrained. According to IS : 800, the effective length of the compression flange will be equal to

Solution:

QUESTION: 9

By how much percentage is the permissible stress in a grillage beam be increased if it is encased in concrete

Solution:

### Beams (Part - 2)

Doc | 3 Pages

### Flanged Beams - Numerical Problems (Part - 2)

Doc | 22 Pages

### Influence Lines for Beams (Part - 2)

Doc | 4 Pages

### Doubly Reinforced Beams: Theory (Part - 2)

Doc | 12 Pages

- Beams - 2
Test | 9 questions | 30 min

- Stresses In Beams - 2
Test | 10 questions | 30 min

- Test: Beams & Slabs - 2
Test | 20 questions | 60 min

- Test: Beams And Slabs- 2
Test | 25 questions | 50 min

- Beams - 1
Test | 10 questions | 30 min