Unconventional Machining Process - 1


10 Questions MCQ Test Manufacturing and Industrial Engineering | Unconventional Machining Process - 1


Description
This mock test of Unconventional Machining Process - 1 for Mechanical Engineering helps you for every Mechanical Engineering entrance exam. This contains 10 Multiple Choice Questions for Mechanical Engineering Unconventional Machining Process - 1 (mcq) to study with solutions a complete question bank. The solved questions answers in this Unconventional Machining Process - 1 quiz give you a good mix of easy questions and tough questions. Mechanical Engineering students definitely take this Unconventional Machining Process - 1 exercise for a better result in the exam. You can find other Unconventional Machining Process - 1 extra questions, long questions & short questions for Mechanical Engineering on EduRev as well by searching above.
QUESTION: 1

The cutting tool used in wire-EDM is made of
1. Brass
2. Copper
3. Tungsten

Which of the above tool is used?

Solution:
QUESTION: 2

Consider the following statements pertaining to plasma arc cutting:
1. Plasma is a hot ionized gas.
2. Plasma can produce very high temperatures.
3. Plasma arc cutting is used only for electrically conductive metals.
4. Wider kerf is produced.

Which of the above are correct?

Solution:

Plasma arc cutting produces very narrow kerf and minimum HA

QUESTION: 3

Which of the following gases is used for cleaning the cat in plasma arc cutting?
1. Argon
2. Oxygen
3. Hydrogen
4. Nitrogen

Solution:
QUESTION: 4

Water is the main, cutting agent in water jet machining. Other cutting fluid used may be

Solution:
QUESTION: 5

The average water jet velocity in water jet machining may be

Solution:
QUESTION: 6

In an electro - chemical machining (E C M ) operation, a square hole of diamensions 5 mm x 5 mm is drilled in a block of copper. The current used is 5000 A. Atomic weight of copper is 63 and valency of dissolution is 1. Faraday’s constant is 96,500 Coulomb. The material removal rate (in g/s) is

Solution:

QUESTION: 7

Which one of the following process conditions leads .to higher MRR\n ECM process?

Solution:

where,
A = gram atomic weight of the metallic ions
I = current (amperes)
p = density of the anode (gm/cm3)
Z = valency of the cation
F = Faraday (= 96,500 coulombs)

QUESTION: 8

Material removed by mechanical action in

Solution:
QUESTION: 9

Material removed by thermal action in

Solution:

Material removal by mechanical action: AJM, Low-stress grinding, USM Material removed by electrical process: Electrochemical deburring, Electrochemical grinding , Electroch emical milling , Electrochemical polishing.
Material removed by thermal process: Electron-beam machining, Electrical discharge grinding, Laser beam machining, Plasma beam machining.
Material removed by chemical process: ECM, Photochemical maching

QUESTION: 10

A titanium sheet of 5 mm thickness is cut by wire-cut EDM process using a wire of 1 mm diameter. A uniform spark gap of 0.5 mm on both sides of the wire is maintained during cutting operation. If the feed rate of the wire into the sheet is 20 mm/min, the material removal rate (in mm3/min) will be

Solution:

Related tests