Description

This mock test of Test: Past 28 Years Questions: Mechanical Properties of Solids for NEET helps you for every NEET entrance exam.
This contains 5 Multiple Choice Questions for NEET Test: Past 28 Years Questions: Mechanical Properties of Solids (mcq) to study with solutions a complete question bank.
The solved questions answers in this Test: Past 28 Years Questions: Mechanical Properties of Solids quiz give you a good mix of easy questions and tough questions. NEET
students definitely take this Test: Past 28 Years Questions: Mechanical Properties of Solids exercise for a better result in the exam. You can find other Test: Past 28 Years Questions: Mechanical Properties of Solids extra questions,
long questions & short questions for NEET on EduRev as well by searching above.

QUESTION: 1

Two wires A and B are of the same material. Their lengths are in the ratio 1 : 2 and the diameter are in the ratio 2 : 1. If they are pulled by the same force, then increase in length will be in the ratio

Solution:

We know that Young's modulus

Since Y, F are same for both the wires, we have,

So, ℓ_{1} : ℓ_{2} = 1 : 8

QUESTION: 2

When an elastic material with Young’s modulus Y is subjected to stretching stress S, elastic energy stored per unit volume of the material is

Solution:

Energy stored per unit volume

stress (stress / Young' s modulus)

(stress)^{2} /( Young ' s modulus)

QUESTION: 3

The compressibility of water is 4 × 10^{–5} per unit atmospheric pressure. The decrease in volume of 100 cm^{3 }of water under a pressure of 100 atmosphere will be

Solution:

Here, P = 100 atm,

K = 4 × 10^{–5} and V = 100 cm^{3}.

Hence, ΔV = 0.4 cm^{3}

QUESTION: 4

The following four wires are made of the same material. Which of these will have the largest extension when the same tension is applied ?

Solution:

So, extension,

[∵ F and Y are constant]

The ratio of is maximum for case (d).

Hence, option (d) is correct.

QUESTION: 5

If the ratio of diameters, lengths and Young’s modulus of steel and copper wires shown in the figure are p, q and s respectively, then the corresponding ratio of increase in their lengths would be [NEET Kar. 2013]

Solution:

From formula, Increase in length

### Introduction - Mechanical Properties of Solids

Video | 05:24 min

### Notes - Mechanical Properties of Solids

Doc | 58 Pages

### Mindmap: Mechanical Properties of Solids

Doc | 1 Page

### Stress - Mechanical Properties of Solids

Video | 10:27 min

- Test: Past 28 Years Questions: Mechanical Properties of Solids
Test | 5 questions | 10 min

- Test: Past 28 Years Questions: Mechanical Properties of Fluids
Test | 6 questions | 10 min

- Test: 35 Year JEE Previous Year Questions: Mechanical Properties of Solids and Fluids
Test | 30 questions | 60 min

- Test: Mechanical Properties of Solids (CBSE Level)
Test | 30 questions | 30 min

- Test: Mechanical Properties - 1
Test | 10 questions | 30 min