Description

This mock test of Electricity - 2 for Class 10 helps you for every Class 10 entrance exam.
This contains 20 Multiple Choice Questions for Class 10 Electricity - 2 (mcq) to study with solutions a complete question bank.
The solved questions answers in this Electricity - 2 quiz give you a good mix of easy questions and tough questions. Class 10
students definitely take this Electricity - 2 exercise for a better result in the exam. You can find other Electricity - 2 extra questions,
long questions & short questions for Class 10 on EduRev as well by searching above.

QUESTION: 1

The correct relation between current 'I' and amount of charge flown 'q' during a time 't' through a conductor is

Solution:

Correct relation is current I =

⇒ q = It

QUESTION: 2

The effective resistance between A and B is

Solution:

6Ω is shorted so effective resistance is 4Ω.

QUESTION: 3

SI unit of resistivity is

Solution:

As resistivity of the material of a resistor of length l, cross-section area A and resistance R is given by :ρ = R.A/I, hence SI unit of resistivity is ohm -metre (Ω m).

QUESTION: 4

A cooler of 1500 W, 200 volt and a fan of 500 W, 200 volt are to be used from a household supply. The rating of fuse to be used is

Solution:

Total power used, P - P_{1} + P_{2} = 1500 + 500 = 2000 W.

Current drawn from the supply,

QUESTION: 5

If four resistors each of 1Ω are connected in parallel, the effective resistance will be

Solution:

If four resistors each of 1Ω are connected in parallel, the effective resistance will be 0.25Ω..

As, in parralel connection,

1/R_{eff.} = 1/R_{1} + 1/R_{2} + ....

QUESTION: 6

A fuse wire repeatedly gets burnt when used with a good heater. It is advised to use a fuse wire of

Solution:

In order to get the working of heater properly, fused wire of higher rating must be used.

QUESTION: 7

Resistivity of a given conductor depends on

Solution:

Resistivity of a given conductor depends only on its material and the temperature. Resistivity does not depend on the dimensions of the conductor.

QUESTION: 8

A coil in the heater consume power P on passing current. If it is cut into halves and joined in parallel, it will consume power

Solution:

Original power consumed, P = V^{2}/R

When used in parallel

R_{P} = R/4

∴ New power consumed when two halves in parallel

QUESTION: 9

A combination of three resistances has been shown here. Effective resistance between the points A and B is

Solution:

Value of series combination of 2Ω and 2Ω resistances = 4Ω. As it is now connected in parallel to 4Ω resistance, hence the effective resistance R between the points A and B will be

QUESTION: 10

If P and V are the power and potential of device, the power consumed with a supply potential V_{1 }is

Solution:

QUESTION: 11

Which alloy is used to prepare the heating element of an electric iron ?

Solution:

An alloy ‘nichrome’ is used to prepare the heating element of an electric iron because its resistivity is high, its melting point is high and it does not oxidise easily.

QUESTION: 12

The resistance of hot filament of the bulb is about 10 times the cold resistance. What will be the resistance of 100 W-220 V lamp, when not in use ?

Solution:

When the lamp is on use, it is hot.

Using joules law of heating ;

P = V^{2} / R

R = 220^{2} /100 = 484 ohm.

It is given resistance of hot lamp is 20 times the cold lamp.

Hence, R cold = 484/10 = 48.4 ohm.

QUESTION: 13

Two electric lamps are rated as 220 V, 100 W and 220 V, 40 W respectively. Their electric resistances are

Solution:

Resistance R = V^{2}/P where V = voltage/potential difference and P - power

∴ electrical resistance of 100 W lamp,

and electrical resistance of 40 W lamp,

QUESTION: 14

If R_{1} and R_{2} be the resistance of the filament of 40 W and 60 W respectively operating 220 V, then

Solution:

Using power,

For the same voltage, R ∝ 1/P

More the power, lesser the resistance.

Accordingly, R_{2} < R_{1}

QUESTION: 15

A wire of resistance 8Ω is bent in the form of a closed circle. What is the effective resistance between the two points A and B, at the ends of any diameter of the circle ?

Solution:

When a wire of 8Ω resistance is bent in the form of a closed circle, resistance of each half (semicircular) part is 8/2 Ω = 4Ω.

As these two parts are connected in parallel across points A and B, hence effective resistance will be 2Ω.

QUESTION: 16

Two resistors are connected in series gives an equivalent resistance of 10Ω. When connected in parallel, gives 2.4Ω. Then the individual resistance are

Solution:

In series, R_{s} = R_{1} + R_{2} = 1OΩ

In parallel,

QUESTION: 17

The rheostat is used in the circuit to :

Solution:

A rheostat is used to increase or decrease the magnitude of the current flowing through a circuit without change in the voltage source.

QUESTION: 18

Calculate the current flows through the 10Ω resistor in the following circuit.

Solution:

In parallel, potential difference across each resistor will remain same. So, current through 10Ω resistor

QUESTION: 19

The graph between current I and potential difference V in the experimental verification of Ohm’s law were drawn by four students. Which one is correct ?

Solution:

I-V graph shown in figure (b) is correct because I ∝ 7.

QUESTION: 20

Two Wires of same length and area, made of two materials of resistivity ρ_{1} and ρ_{2} are connected in parallel V to a source of potential. The equivalent resistivity for the same length and area is

Solution:

### Current Electricity - Quiz 2

Video | 54:07 min

### Current Electricity - Lecture 2

Video | 49:35 min

### Electricity

Doc | 37 Pages

### Household Electricity Supply, Electricity

Video | 28:29 min

- Electricity - 2
Test | 20 questions | 20 min

- QUIZ 2:Current Electricity(#freetestseries)
Test | 15 questions | 20 min

- Current Electricity MCQ Level - 2
Test | 10 questions | 45 min

- Test: Electricity - 4
Test | 25 questions | 25 min

- Test: Electricity - 3
Test | 25 questions | 25 min