Calculate the volume (cubic meter) of earthwork for an embankment of length 30 m and width 4 m. The mean depth of the embankment is 4 m and side slope is 2: 1. Using mid-sectional area method.
1 Crore+ students have signed up on EduRev. Have you? Download the App |
Find out the set among the four sets which is like the given set.
Given set is (63, 54, 45)
A sample of saturated clay has a porosity of 0.562. The void ratio of the clay is;
A mild steel wire is 10 mm in diameter and 1 mm long. If a wire is subjected to an axial tensile load of 10 kN, find the extension in the rod. (Take E = 200 x 109)
The type of weld used to connect two plates at a lap joint is called-
If H is the total height of the building, then under transient wind load, the lateral sway at the top should not exceed -
According to IS code, the flexural strength in (N/mm2) is given as:
Continuity equation is based on the principle of conservation of
Rapid setting cement contains a relatively higher proportion of
Which of the following is an obstacle in chaining but not in ranging?
For the design of cement concrete pavement, for corner loading, IRC recommends the use of-
The best-suited rolled steel section for a tension member is
A circular shaft of diameter D is subjected to a torque T. The maximum shear stress of the shaft will be-
Crushing strength of good building stone should be more than:
Sum of the specific yield and specific retention is-
Side face reinforcement is provided in a beam when the depth of web exceeds-
If B is the width of the beam and D is the overall depth d is the effective depth then, Maximum tension reinforcement in concrete structure is given by :
According to Le Chatelier Method for testing soundness of cement the unaerated ordinary rapid hardening and low heat Portland cement should not have an expansion of more than :
IS code for standard penetration test in the soil is:
Settlement of soil under compressive force due to the expulsion of water from pores is known as -
A flat plate is welded to a gusset plate by a fillet weld of size 10 mm. The angle between the fusion faces and the effective length of the weld is 85° and 300 mm respectively. If the axial factored load acting on the plate is 250 kN, then the average shear stress produced in the weld is
Aggregates affecting the durability of concrete most are: