Courses

# Test: Theory of Machines Level - 4

## 25 Questions MCQ Test Mechanical Engineering SSC JE (Technical) | Test: Theory of Machines Level - 4

Description
This mock test of Test: Theory of Machines Level - 4 for Mechanical Engineering helps you for every Mechanical Engineering entrance exam. This contains 25 Multiple Choice Questions for Mechanical Engineering Test: Theory of Machines Level - 4 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Theory of Machines Level - 4 quiz give you a good mix of easy questions and tough questions. Mechanical Engineering students definitely take this Test: Theory of Machines Level - 4 exercise for a better result in the exam. You can find other Test: Theory of Machines Level - 4 extra questions, long questions & short questions for Mechanical Engineering on EduRev as well by searching above.
QUESTION: 1

Solution:
QUESTION: 2

Solution:
QUESTION: 3

### The reference point on the follower to lay the cam profile is known as the

Solution:
QUESTION: 4

Cam and follower mechanism constitutes a kinematic pair of the type

Solution:
QUESTION: 5

Surface stresses are minimum in a cam follower arrangement with

Solution:
QUESTION: 6

The prime circle of a cam is

Solution:
QUESTION: 7

The cam size depends upon

Solution:
QUESTION: 8

Identify the nature of motion in a cam– roller followers system that leads to lowest jerk

Solution:
QUESTION: 9

Cam size depends upon

Solution:
QUESTION: 10

Pitch point on a cam is

Solution:
QUESTION: 11

The tooth profile most commonly used in gear drive for power transmission is

Solution:
QUESTION: 12

The size of gears is usually specific by

Solution:
QUESTION: 13

The contact ratio of gears is always

Solution:
QUESTION: 14

Select the positive drive amongst the following:

Solution:
QUESTION: 15

The motion transmitted between the teeth of two spur gears is generally

Solution:
QUESTION: 16

Minimum number of teeth for involute rack and pinion arrangement for pressure angle if 20º is

Solution:
QUESTION: 17

For helical gears, the helix angle generally ranges from

Solution:
QUESTION: 18

Tumbler gears are

Solution:
QUESTION: 19

The size of Gear is specific by

Solution:
QUESTION: 20

If D is pitch circle diameter and T is the number of teeth then its circular pitch is

Solution:
QUESTION: 21

The product of diameter pitch and circular pitch is

Solution:
QUESTION: 22

A rack is a gear of infinite

Solution:
QUESTION: 23

The stub tooth is

Solution:
QUESTION: 24

In gear drive, standard addendum equals

Solution:
QUESTION: 25

Common contact ratio f a pair of spur pinion

Solution: