Technical Test SSC JE: Electrical Engineering (EE)- 7


52 Questions MCQ Test Electrical Engineering SSC JE (Technical) | Technical Test SSC JE: Electrical Engineering (EE)- 7


Description
This mock test of Technical Test SSC JE: Electrical Engineering (EE)- 7 for Electrical Engineering (EE) helps you for every Electrical Engineering (EE) entrance exam. This contains 52 Multiple Choice Questions for Electrical Engineering (EE) Technical Test SSC JE: Electrical Engineering (EE)- 7 (mcq) to study with solutions a complete question bank. The solved questions answers in this Technical Test SSC JE: Electrical Engineering (EE)- 7 quiz give you a good mix of easy questions and tough questions. Electrical Engineering (EE) students definitely take this Technical Test SSC JE: Electrical Engineering (EE)- 7 exercise for a better result in the exam. You can find other Technical Test SSC JE: Electrical Engineering (EE)- 7 extra questions, long questions & short questions for Electrical Engineering (EE) on EduRev as well by searching above.
QUESTION: 1

A stand alone engine driven synchronous generator is feeding a partly inductive load. A capacitor is now connected across the load to completely nullify the inductive current. For this operation condition

Solution:

QUESTION: 2

A transistor may be used as a switching device or as a

Solution:
QUESTION: 3

In an ideal transformer primary and secondary induced emfs are

Solution:

QUESTION: 4

Factors affecting the values of resistances are

Solution:

QUESTION: 5

The function of starter in dc motor is to

Solution:

QUESTION: 6

Time delay relay is used

Solution:
QUESTION: 7

Murray loop test is used to locate the

Solution:

Murray loop test is the most common and accurate method for locating earth faults and short-circuit faults.

QUESTION: 8

The maximum efficiency for a transformer occurs at 80% of full load. Its core is Pc and ohmic loss is Poh at full load. For this, transformer, the ratio of Pc/Poh is

Solution:

QUESTION: 9

At low speed of three brush generator

Solution:

QUESTION: 10

The rotor of a stepper motor has no

Solution:

QUESTION: 11

A ceiling fan uses

Solution:

QUESTION: 12

The small pockets of air in the high voltage cable provide _____ relative permittivity,____ electric field and at these sites breakdown is likely to be initiated

Solution:

QUESTION: 13

Which of the following is correct ?

Solution:
QUESTION: 14

As compared to shunt and compound motors series motor have the highest torque becauseof its comparatively ____ at the start

Solution:
QUESTION: 15

Which element is used for making an electric iron element ?

Solution:
QUESTION: 16

A 2 cm long coil has 40 turns and carries a current of 650 mA. The magnetising force of the coil is

Solution:

QUESTION: 17

In a parallel a.c. circuit power loss is due to

Solution:
QUESTION: 18

An electric pyrometer is an instrument used to measure

Solution:
QUESTION: 19

A 200/100 V, 10 KVA transformer has 60 transformation ratio of the transformer ?

Solution:

QUESTION: 20

A synchronous capacitor is an over-excited motor running at

Solution:
QUESTION: 21

If 2% of the main current is to be passed through a galvanometer of resistance G, then resistance of the shunt required is

Solution:

QUESTION: 22

Star-delta starter of an induction motor

Solution:

Correct Answer :- C

Explanation : The Star Delta Starter is a very common type of starter and is used extensively as compared to the other type of starting methods of the induction motor. A star delta is used for a cage motor designed to run normally on the delta connected stator winding.

Since the developed torque is proportional to the square of the voltage applied to an stator. Star delta starter reduces the starting torque to one-third that is obtained by direct delta starting.

QUESTION: 23

In the circuit shown in the figure, i(t) is a unit step current. The steady-state value of v(t) is

Solution:

QUESTION: 24

Two coils have self inductances of 0.09 H and 0.01 H and mutual inductance of 0.015 H. The coefficient of coupling between the coils is

Solution:

QUESTION: 25

The configuration that can be used as a constant current source is

Solution:
QUESTION: 26

The DC current gain of a transistor in CE configuration is 100. Find its DC current gain in common base configuration

Solution:

QUESTION: 27

Starting torque of synchronous motor is

Solution:
QUESTION: 28

The maximum power developed in the synchronous motor will depend on

Solution:
QUESTION: 29

In an ac circuit Isinf is called

Solution:
QUESTION: 30

In the circuit shown in the figure below, the current supplied by the sinusoidal current source I is

Solution:

QUESTION: 31

Which of the following motors one will choose to drive the rotary compressor ?

Solution:
QUESTION: 32

The degree of mechanical vibrations produced by the laminations of a transformers depends on

Solution:
QUESTION: 33

A piece of oil soaked paper has been inserted between the plates of a parallel plate capacitor.Then the potential difference between the plates will

Solution:
QUESTION: 34

A coil with a certain number of turns has a specified time constants. If the number of turns is doubled, its time constant would

Solution:

On doubling number of turns, inductance becomes four times as inductance is proportional to number of turns squared and resistance is only doubled, since time constant is inductance upon resistance, new time constant becomes 2T.

QUESTION: 35

To maximize the driving torque in an induction type instrument, flux produced by shunt coil and series coil should be

Solution:
QUESTION: 36

If the supply polarity to the armature terminal of a separately excited d.c. motor is reversed, the motor will run under

Solution:
QUESTION: 37

Which of the following motor has high starting torque ?

Solution:
QUESTION: 38

Hysteresis loss in a dc machine are proportional to

Solution:
QUESTION: 39

In power station practice "spinning reserve" is

Solution:
QUESTION: 40

Grounding is generally done in transmission line at

Solution:
QUESTION: 41

For an electric arc welding the current range is usually

Solution:
QUESTION: 42

Current flow in a semiconductor depends on the phenomenon of

Solution:
QUESTION: 43

Maxwell inductance bridge is used for coil of Q value

Solution:
QUESTION: 44

Which one of the following is used for the measurement of 3-f power factor ?

Solution:

QUESTION: 45

The speed of the meter disc on full load is kept the lowest possible in order to

Solution:
QUESTION: 46

The current and potential coil of a wattmeter were accidentally interchanged while connecting.After energizing the circuit, it was observed that the wattmeter did not show the reading. This could be due to

Solution:
QUESTION: 47

Which voltmeter would you select for measuring 50000 V direct current ?

Solution:
QUESTION: 48

The secondary of CT is never left open circuited because otherwise

Solution:
QUESTION: 49

Rated breaking capacity (MVA) of a circuit breaker is equal to

Solution:
QUESTION: 50

While using air blast circuit breaker, current chopping is a phenomenon often observed when

Solution:
QUESTION: 51

The arc voltage in a circuit breaker is

Solution:
QUESTION: 52

The transformer efficiency at relatively light loads is quite low. This is due to

Solution: