Test: Basic Electronics - 6


25 Questions MCQ Test Electrical Engineering SSC JE (Technical) | Test: Basic Electronics - 6


Description
This mock test of Test: Basic Electronics - 6 for Electrical Engineering (EE) helps you for every Electrical Engineering (EE) entrance exam. This contains 25 Multiple Choice Questions for Electrical Engineering (EE) Test: Basic Electronics - 6 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Basic Electronics - 6 quiz give you a good mix of easy questions and tough questions. Electrical Engineering (EE) students definitely take this Test: Basic Electronics - 6 exercise for a better result in the exam. You can find other Test: Basic Electronics - 6 extra questions, long questions & short questions for Electrical Engineering (EE) on EduRev as well by searching above.
QUESTION: 1

In an A.C. circuit, a low value of kVAR compared with kW indicates –

Solution:
QUESTION: 2

In A.C. circuit laminated iron is invariably used in order to –

Solution:
QUESTION: 3

The ratio of active power to apparent power is known as ...... factor.

Solution:
QUESTION: 4

In an A.C. circuit power is dissipated in –

Solution:
QUESTION: 5

In a parallel R-C circuit, the current always .... the applied voltage.

Solution:
QUESTION: 6

At very two frequencies a series R-C circuit behaves as almost purely .....

Solution:
QUESTION: 7

The power is measured in terms of decibles in case of

Solution:
QUESTION: 8

The power taken by a 3 - f load is given by the expression –

Solution:
QUESTION: 9

For the full wave rectified sine wave the r.m.s. value is –

Solution:
QUESTION: 10

Which of the following waves has the highest value of peak factor ?

Solution:
QUESTION: 11

The frequency of domestic power supply in India is–

Solution:
QUESTION: 12

The negative maximum of a cosine wave occurs at –

Solution:
QUESTION: 13

Ohm is the unit of all of the following except –

Solution:
QUESTION: 14

The power factor of a D.C. circuit is always –

Solution:
QUESTION: 15

The product of apparent power and cosine of the phase angle between circuit voltage and current is –

Solution:
QUESTION: 16

While drawing vector diagram for a series circuit the reference vector is

Solution:
QUESTION: 17

In A.C. circuit the power curve is a sine wave having–

Solution:
QUESTION: 18

The value of operator j2 is equal to –

Solution:
QUESTION: 19

Higher the Q of a series circuit–

Solution:
QUESTION: 20

The ratio of the bandwidth to the resonance frequency is called the......of the circuit.

Solution:
QUESTION: 21

Which of the following statement is in-correct ?

Solution:
QUESTION: 22

A network is said to be non-linear if it does not satisfy –

Solution:
QUESTION: 23

Which of the following is not a non-linear element?

Solution:
QUESTION: 24

A coil with large distributed capacitance has a –

Solution:
QUESTION: 25

The dual of a loop is –

Solution:

Related tests