Courses

Test: Communication System- 5


25 Questions MCQ Test Basic Electronics Engineering for SSC JE (Technical) | Test: Communication System- 5


Description
This mock test of Test: Communication System- 5 for Electrical Engineering (EE) helps you for every Electrical Engineering (EE) entrance exam. This contains 25 Multiple Choice Questions for Electrical Engineering (EE) Test: Communication System- 5 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Communication System- 5 quiz give you a good mix of easy questions and tough questions. Electrical Engineering (EE) students definitely take this Test: Communication System- 5 exercise for a better result in the exam. You can find other Test: Communication System- 5 extra questions, long questions & short questions for Electrical Engineering (EE) on EduRev as well by searching above.
QUESTION: 1

One of the advantages of base modulation over collector modulation of a transistor class C amplifier is

Solution:
QUESTION: 2

The Hartley-Shannon theorem sets a limit on the

Solution:
QUESTION: 3

Which one of the following statement is correct? The equalizing pulses in television transmission are sent during

Solution:
QUESTION: 4

In television, 4 : 3 represents the
Solution:
QUESTION: 5

Equalising pulses in TV are sent during
Solution:
QUESTION: 6

Ghost in a television picture is due to
Solution:
QUESTION: 7

In a PLL
Solution:
QUESTION: 8

A PLL can be used to demodulate
Solution:
QUESTION: 9

The most common detector used in an AM radio broadcast receiver is
Solution:
QUESTION: 10

Which one of the following statements is correct
Solution:
QUESTION: 11

An AM signal is detected using an envelope detector. The carrier frequency and modulating signal frequency are 1 MHz and 2 kHz respectively. An appropriate value for the time constant of the envelope detector is
Solution:
QUESTION: 12

The input to a coherent detector is DSB-SC signal plus noise. The noise at the detector output is
Solution:
QUESTION: 13

Foster Seeley discriminator is used for
Solution:
QUESTION: 14

A message signal m(t) = cos 2000 π t + 4 cos 4000 pt modulates the carrier c(t) = cos 2 π fct where fc = 1 MHz to produce an AM signal. For demodulating the generated AM signal usingan envelope detector, the time constant RC of the detector circuit should satisfy
Solution:
QUESTION: 15

The diagonal clipping in amplitude demodulation (using envelope detector) can be avoided if
RC time-constant of the envelope detector satisfies the following condition, (here W is message bandwidth and ωc is) carrier frequency both in rad/sec)
Solution:
QUESTION: 16

The choice of the product RC in a simple envelope detector using a diode and an RC circuit is governed by
Solution:
QUESTION: 17

It the input is a DSB-SC signal plus noise, what will be noise at the detector
Solution:
QUESTION: 18

Which of the following pulse modulation is analog
Solution:
QUESTION: 19

Consider the following

1. Pulse-position modulation

2. Pulse-code modulation

3. Pulse-width modulation

Which of these communications are not digital
Solution:
QUESTION: 20

Increased pulse-width in the flat-top sampling, leads to
Solution:
QUESTION: 21

A PWM signal can be generated by
Solution:
QUESTION: 22

A PAM signal can be detected by using
Solution:
QUESTION: 23

PAM signals are constructed by using a low pass filter of pass band slightly greater than base band to avoid aliasing. This avoids distortion
Solution:
QUESTION: 24

The most noise immune system is
Solution:
QUESTION: 25

Which one of the following pairs is not correctly matched
Solution:

Recommended Content

Recommended Tests

Related tests

Follow Us
© 2015-20 EduRev