Electrical Machines And Power Systems - MCQ Test 1


10 Questions MCQ Test Mock Test Series for Electrical Engineering (EE) GATE 2020 | Electrical Machines And Power Systems - MCQ Test 1


Description
This mock test of Electrical Machines And Power Systems - MCQ Test 1 for GATE helps you for every GATE entrance exam. This contains 10 Multiple Choice Questions for GATE Electrical Machines And Power Systems - MCQ Test 1 (mcq) to study with solutions a complete question bank. The solved questions answers in this Electrical Machines And Power Systems - MCQ Test 1 quiz give you a good mix of easy questions and tough questions. GATE students definitely take this Electrical Machines And Power Systems - MCQ Test 1 exercise for a better result in the exam. You can find other Electrical Machines And Power Systems - MCQ Test 1 extra questions, long questions & short questions for GATE on EduRev as well by searching above.
QUESTION: 1

In practice, while performing O.C. test on transformer input voltage applied to__________ winding, while performing S.C.test input voltage applied to________________winding.

Solution:
QUESTION: 2

In a single phase, full wave bridge circuit and in three phase, delta full wave bridge circuit, the ripple voltage frequency is always 

Solution:
QUESTION: 3

A 3φ, Induction Motor had Tmax as 300 N-m with a supply of 440 V, 50 Hz. If the supply is changed to 220 V, 25 Hz new Tmax is

Solution:
QUESTION: 4

The operating range of slip of an induction machine when it is operating in generating mode

Solution:
QUESTION: 5

In a capacitor start induction motor the power factor of main winding is 0.866 lag. The power factor of auxiliary winding should be      

Solution:
QUESTION: 6

A 4 pole dynamo with wave wound armature has 51 slots containing 20 conductors in each slots. The induced emf is 357 volts and the speed is 8500rpm. The flux per pole will be

Solution:
QUESTION: 7

A 4 pole short shunt wave wound compound generator supplies 25 kW at terminal voltage of 500 V. The armature resistance is 0.1 Q, series field resistance is 0.15 Q and shunt field resistance is 126.875 Q. The emfgenerated is____________

Solution:
QUESTION: 8

A 230 V d.c. series motor develops its rated output at 1500 rpm while taking 20 A. Armature and series field resistance are 0.6 Q and 0.4 Q respectively. To obtain rated torque at 1000 rpm, external resistance mustbe added is____________

Solution:
QUESTION: 9

A shut Machine Connected to 250 V supply has an armatureresistance of 0.12 Ω and field  resistance of 100 Ω.  Then the ratio of the speed of machine as a generator to the machine as a motor, if the line current is 80A in both cases is____________

Solution:
QUESTION: 10

A 3φ, 50 Hz, 400 V, induction motor with 10 poles, running at speed of 540 rpm. If the number of poles reduced to 8, the newoperating slip is____________

Solution: