 |  Metrology & Inspection 20 Flashcards |  Start |
 | What is the term for the intentional difference between the basic dimensions of mating parts? |  Card: 1 / 20 |
| Allowance | Card: 2 / 20 |
| Which type of fit occurs when the lower limit of the hole is greater than the upper limit of the shaft? | Card: 3 / 20 |
| Clearance Fit | Card: 4 / 20 |
| True or False: The mean deviation is the arithmetical mean of lower and upper deviations. | Card: 5 / 20 |
| True | Card: 6 / 20 |
| Fill in the blank: The ______ is the theoretical size that is common to both parts of a mating pair. | Card: 7 / 20 |
| Basic Size | Card: 8 / 20 |
| Riddle: I control how much room there is between two parts, sometimes allowing space, sometimes causing a tight fit. What am I? | Card: 9 / 20 |
| Fit | Card: 10 / 20 |
|  Unlock all Flashcards with EduRev Infinity Plan Starting from @ ₹99 only | |
| Which system allows for variation in size on only one side? | Card: 11 / 20 |
| Unilateral Limit System | Card: 12 / 20 |
| What is the maximum permissible variation in a dimension known as? | Card: 13 / 20 |
| Tolerance | Card: 14 / 20 |
| In the three-wire system, what does Dp represent? | Card: 15 / 20 |
| Pitch diameter | Card: 16 / 20 |
| True or False: The plug gauge is used to check the external features of a component. | Card: 17 / 20 |
| False. The plug gauge is used to check the internal dimensions of a hole. | Card: 18 / 20 |
| Fill in the blank: The ______ describes the maximum height difference between the highest peak and the deepest valley in a surface profile. | Card: 19 / 20 |
| Peak To Valley Height (RT OR RMAX) | Card: 20 / 20 |
| Completed! Keep practicing to master all of them. |  Restart |
