Chapter 3 Power Amplifier - Notes, Basic Electronics, Electrical Engineering Electrical Engineering (EE) Notes | EduRev

Created by: Pioneer Academy

Electrical Engineering (EE) : Chapter 3 Power Amplifier - Notes, Basic Electronics, Electrical Engineering Electrical Engineering (EE) Notes | EduRev

The document Chapter 3 Power Amplifier - Notes, Basic Electronics, Electrical Engineering Electrical Engineering (EE) Notes | EduRev is a part of Electrical Engineering (EE) category.
All you need of Electrical Engineering (EE) at this link: Electrical Engineering (EE)

Chapter 3

POWER AMPLIFIER

POWER AMPLIFIER-Large Signal Amplifier Power amplifier are meant for large signal amplification power stage is normally the final stage of a cascade amplifier and driver. The energy conversion device i.e. speaker, antenna or transducer etc. The power amplifier does not actually amplifier the power, instead it takes power from the dc power supply connected to the power circuit and converts into use full ac signal power Zin ® high. Zout ® low, heat sink are used.

Class A Here the dc bias is adjusted much less than its cut off value so that the output current flow for full input voltage cycle.
Feature: 1. Minimum distortion. 2. Since the output contains only one frequency component, the output power is small. 3. Efficiency is low. 4. Used as voltage amplifier as modulating amplifier.

Class B Here the dc bias is adjusted equal to the cut off value so that the output current flow for half of the input voltage cycle. Hence the output dc component will be always equal to zero.

Feature:
1. High distortion
2. High power output
3. Efficiency is large
4. Used as power amplifier as modulated amplifier.

Class AB Here the dc bias is adjusted slightly less than is cut-off value so that the output current flows for more than half but less than input voltage cycle. This class of amplifier is just a compromise between class A and class B amplifier.

Feature:
1
. Output power is medium
2. Medium distortion
3. Medium efficiency
4. Used as modulating amplifier
5. Used with untuned power amplifier.

Class C Here the dc bias is adjusted greater than its cutoff value so that the output current flow for less than half of the input voltage cycle.
Therefore the output current will be in the from of pulses which will be highly rich in harmonic i.e. frequency multiplier.

Feature:
1
. Very high output power due to rich in harmonic
2. Very high distortion
3. Very high conversion efficiency
4. Used as only modulated amplifier when the need is to raise the power level before transmission
5. Used with tuned frequency amplifier.

Chapter 3 Power Amplifier - Notes, Basic Electronics, Electrical Engineering Electrical Engineering (EE) Notes | EduRev Chapter 3 Power Amplifier - Notes, Basic Electronics, Electrical Engineering Electrical Engineering (EE) Notes | EduRev

 

 

Content Category

Related Searches

mock tests for examination

,

Semester Notes

,

Exam

,

MCQs

,

Electrical Engineering Electrical Engineering (EE) Notes | EduRev

,

Electrical Engineering Electrical Engineering (EE) Notes | EduRev

,

Objective type Questions

,

Extra Questions

,

ppt

,

Basic Electronics

,

Chapter 3 Power Amplifier - Notes

,

Basic Electronics

,

Chapter 3 Power Amplifier - Notes

,

pdf

,

Summary

,

study material

,

practice quizzes

,

Free

,

Chapter 3 Power Amplifier - Notes

,

Electrical Engineering Electrical Engineering (EE) Notes | EduRev

,

past year papers

,

Previous Year Questions with Solutions

,

Sample Paper

,

Viva Questions

,

shortcuts and tricks

,

video lectures

,

Basic Electronics

,

Important questions

;