Mechanical Engineering Exam  >  Mechanical Engineering Tests  >  Test: Fits & Tolerance - 1 - Mechanical Engineering MCQ

Test: Fits & Tolerance - 1 - Mechanical Engineering MCQ


Test Description

10 Questions MCQ Test - Test: Fits & Tolerance - 1

Test: Fits & Tolerance - 1 for Mechanical Engineering 2024 is part of Mechanical Engineering preparation. The Test: Fits & Tolerance - 1 questions and answers have been prepared according to the Mechanical Engineering exam syllabus.The Test: Fits & Tolerance - 1 MCQs are made for Mechanical Engineering 2024 Exam. Find important definitions, questions, notes, meanings, examples, exercises, MCQs and online tests for Test: Fits & Tolerance - 1 below.
Solutions of Test: Fits & Tolerance - 1 questions in English are available as part of our course for Mechanical Engineering & Test: Fits & Tolerance - 1 solutions in Hindi for Mechanical Engineering course. Download more important topics, notes, lectures and mock test series for Mechanical Engineering Exam by signing up for free. Attempt Test: Fits & Tolerance - 1 | 10 questions in 30 minutes | Mock test for Mechanical Engineering preparation | Free important questions MCQ to study for Mechanical Engineering Exam | Download free PDF with solutions
Test: Fits & Tolerance - 1 - Question 1

The term '‘Allowance1’ in limits and fits is usually referred to

Test: Fits & Tolerance - 1 - Question 2

Which of the following is the correct way of designating fit

1 Crore+ students have signed up on EduRev. Have you? Download the App
Test: Fits & Tolerance - 1 - Question 3

Drilled holes and honed holes could be designated by following grades respectively

Test: Fits & Tolerance - 1 - Question 4

Newall system of limits and fits is the oldest system working on hole basis system. The grades of holes and shafts specified respectively are

Test: Fits & Tolerance - 1 - Question 5

ISA tolerance system consists of following numbers of qualities of tolerance, and grades of fit respectively

Test: Fits & Tolerance - 1 - Question 6

The geometric tolerance that does not need a datum for fits specification is

Detailed Solution for Test: Fits & Tolerance - 1 - Question 6

Concentricity, run out and perpendicularity are all measured with respect to some reference datum line
Flatness needs not any reference (or) datum line

Test: Fits & Tolerance - 1 - Question 7

In limits and fits system, basic shaft system is one whose

Test: Fits & Tolerance - 1 - Question 8

Surface roughness on a drawing is represented by

Test: Fits & Tolerance - 1 - Question 9

 Tolerance on the dimension x in the two component assembly shown below is

Detailed Solution for Test: Fits & Tolerance - 1 - Question 9

For equal bilateral tolerances, the tolerance of the gap is

Test: Fits & Tolerance - 1 - Question 10

For grade IT7, value of tolerance is equal to

Information about Test: Fits & Tolerance - 1 Page
In this test you can find the Exam questions for Test: Fits & Tolerance - 1 solved & explained in the simplest way possible. Besides giving Questions and answers for Test: Fits & Tolerance - 1, EduRev gives you an ample number of Online tests for practice

Top Courses for Mechanical Engineering

Download as PDF

Top Courses for Mechanical Engineering