Test: Tension Members - 2 - Civil Engineering (CE) MCQ
10 Questions MCQ Test - Test: Tension Members - 2
A single angle is connected by one leg only. If the area of outstanding leg is x, net area of connecting leg is y, and k is reduction factor whose value is less than 1, then the net effective area of angle in tension will be:
What is the effective net width of plate shown in figure for carrying tension?
| 1 Crore+ students have signed up on EduRev. Have you? Download the App |
Consider the following statements:
Lug angles are used to
1. increase the lengths of the end connections of angle section.
2. decrease the lengths of the end connections of angle section.
3. increase the lengths of the end connections of channel section.
4. decrease the lengths of the end connections of channel section.
Which of these statements are correct?
Lug angles are used to
1. increase the lengths of the end connections of angle section.
2. decrease the lengths of the end connections of angle section.
3. increase the lengths of the end connections of channel section.
4. decrease the lengths of the end connections of channel section.
Failure of tension member is considered when either of following statement is true
1. Excessive elongation in member.
2. Rupture of critical section.
3. Buckling of member.
4. Shear block failure of end connection.
In a tension member if one or more than one rivet hole are off the line, the failure of the member depends upon
Tacking rivets in tension members, are provided at a pitch in line not exceeding
For double angles carrying tension placed back to back and connected to either side of the gusset plate, the sectional area of the section, is equal to gross sectional area of
Match List-I (Type of stress) with List-ll (Allowable value of stress) and select the correct answer using the codes given below the lists:
(fy = minimum yield stress of steel)
For a single section used as a tension member, the given area is assumed
A tension member, if subjected to possible reversal of stress due to wind or earthquake the slenderness ratio of the member should not exceed
Top Courses for Civil Engineering (CE)
Important Questions for Tension Members - 2
Tension Members - 2 MCQs with Answers
Online Tests for Tension Members - 2
|
© EduRev
|
Education Revolution
|
Follow Us
|
