Test: Circuit Theorems- 3 - Electrical Engineering (EE) MCQ

Assuming the op-amp to be ideal, the input admittance of the op-amp shown below is

In the π-circuit shown below, the current through the 2 Ω, resistor is

Match List-I (Elements) with List-ll (Type) and select the correct answer using the codes given below the lists:

Codes:

The equivalent resistance of the given circuit is

The maximum power that a 12 V d.c. source with an interna! resistance of 2 Ω can supply toa resistive load is

The Norton’s equivalent circuit for the circuit shown below across the terminals X-Y can be represented as a current source (I_N) connected across a resistance (R_N). The value of I_N and R_N are respectively

To effect maximum power transfer to the load, Z_L (W) for the circuit shown below should be​

In order to apply superposition theorem, it is necessary that the network be only

A network N is to be connected to a load of 500 ohms. If the Thevenin’s equivalent voltage and Norton’s equivalent current of N are 5 volts and 10 mA respectively, the current through the load will be

If all the elements in a particular network are linear, then the superposition theorem would hold, when the excitation is

The maximum value of power transferred to the load Z_L shown in figure below is

In the circuit shown below, the current through the inductive reactance is

Which of the following theorems is applicable for both linear and non-linear circuits?

While determining R_Th of a circuit
1. voltage and current sources should be left as they are.
2. all independent current and voltage sources are short-circuited.
3. all sources should be replaced by their source resistances.
4. all dependent sources remain as they are.
Q. Which of the statements is/are true in relation of R_Th?

For the circuit given in figure below, the Thevenin’s voltage and resistance as seen at “AB" are respectively​

Consider the following statements about Norton’s equivalent of a circuit across a given two load terminals:
1. Norton’s equivalent resistance is the same as Thevenin’s equivalent resistance R_Th.
2. Norton’s equivalent is the voltage equivalent of the network.
3. The load is connected in parallel to the Norton’s equivalent resistance.
Out of the above statements, which statements hold true?

When the power transferred to the load is maximum, the efficiency is