For a single phase capacitor start induction motor which of the following is valid ?
To avoid arcing, connect suitable value of in earthing
1 Crore+ students have signed up on EduRev. Have you? Download the App |
What is the value of the current I in the circuit shown below ?
In the following type of conductors the corona is minimum in
Consider the following w.r.t. the circuit as shown below
Which of the above statements is/are correct?
If the time delay of relay with TMS setting 0.1 is 10 second then what is the time delay when the TMS setting is changed to 0.5
The machine used in wind will is
In an RLC series resonant circuit, if the maximum stored energy is increased by 10%and at the same time, the energy dissipated per cycle is reduced by 10%, it will result in which one of the following ?
Consider the following components Out of these components, which component(s)can be common for primary & back up protection
In a series resonance circuit, at resonance selectivity Q is equal to
Positive sequence terminal voltage is zero in
Most economical load in the underground cable is
A certain network consist of a large number of ideal linear resistances, one of which is
designated consumed by R is P1 when only the first source is active, and P2 when only the
second source is active, if both source are active simultaneously, then the power consumed by R
is
Consider the following statement about D'Arsonval Movement
1. It is best suited for d.c. current measurement
2. It responds to the average value of current
3. It could be used for power measurements
Which of these statements is/are correct
Torque/weight ratio of an instrument indicates
A current transformer has a phase error of +3º. The phase angle between the primary andsecondary current is
The direction of rotation of a d.c. series motor can be changed by
A three phase transformer having zero sequence impedance of Zo has the zero-sequence network as shown in the figure below. The connection of its windings are
The transformer laminations are insulated from each other by
A coil with certain number of turns has a specified time constant. If the no. of turns is doubled, its time constant would
The technique of adding a precise amount of time between the trigger point and the beginning of the scope-sweep in a CRO is known as
In a CE (common emitter) transistor, VCC = 12V and the zero signal collector current is 1mA. Determine the operating point when collector load (RC) is 6 KW
A 100 H.P. motor with a synchronous speed of 720 rpm at 50 Hz has 96 stator slots with4 conductors per slot and 120 rotor slots with 2 conductors per slot. If the full load efficiency is 0.92 and the p.f. is 0.9 lagging, the current per phase when the stator is star connected to3-phase, 500V supply will be
Which of the following application requires high starting torque ?
Which DC motor will be preferred for machine tools ?
The empty space between the plates of a capacitor is filled with liquid of dielectricconstant K the capacitance of capacitor
If current through the operating coil of a moving iron instrument is doubled, the operating forcebecomes
A magnetic needle is kept in a uniform magnetic field. It experiences
Disadvantage of low p.f. is