90 CATIA assembly Tutorial Compass Positioning Video Lecture - Learning

tutorial 90 assembly for Katia in the
previous tutorial we keep learning how
to position our parts and adding
constraints and we use the constraint
toolbox and manipulation toolbox and
also we use another in the beginning is
when we are inserting a new part how you
also can positioning when you are
inserting them we always choose part two
here and here you are every to position
your part as well so and here you can
check either to make between the
constraint or not so we have different
ways to position the parts and in this
story we're going to show you another
type for positioning using the compass
so in the beginner tutorials we show you
how to translate a part single part
moving rotating it also you can do the
same thing in the assembly workbench and
a simple your for you do to the compass
for example let's add the compass on
that edge you just try it another
picture click that surface because when
you are go it on the edge you're going
to click that edge or the surface so
let's pick this surface and now you
notice that we have different directions
where you can move your part program if
you double-click on that and let's
change the direction to be put in apply
so you notice that you move that part so
you can again change to the direction
you want apply so if you are satisfied
with that distance and you
kheh click close also you can directly
drag it the direction you want here to
and let's now take comes back now let's
try to rotate the bar let's add the
compass on that edge and you can notice
here where you can rotate the part or
double click to add a specific angle
value
now you are to the slide with
positioning gun take it back again
so after this tutorial we now knew the
different type of positioning as we
showed you for example at the beginning
when you are assuming you're able to
position your part you have the
constraint powers you have the
manipulation and snap to burst and you
have the compass and all it's depending
on the user which with the e point it is
easier or faster so I hope that was
useful