AutoCAD 2015 Drawing Limits Setting Tutorial Video Lecture | A complete Guide to AutoCAD (English) - Design Softwares

in this tutorial we will learn limits
command
so for limits you have to type Li M only
first three characters then press ENTER
then specified load left corner so lower
left corner you have to set always add
zero comma zero position and press ENTER
then upper right corner so your operate
corner will depend on which drawing you
are creating suppose if I want to create
this ring the total length is 75 and you
have to take extra space around the
object so suppose I will take hundred by
hundred hundred commander so in that
space this object will be placed
properly and it will have extra space
also around the object so I will give
the upper right corner as 100 comma
hundred enter so it has accepted 0 comma
0 and and 100 comma 100 after limits
here to apply the limits here it has
accepted the values but limits has not
been applied so to apply the limits here
to give zoom all so for zoom all here to
busy
short cut for zoom red enter and a for
all that means after limits you will
have to use the Z enter a enter without
that limits will not be applied and if
we see the limit command again limits
enter so there is two button extra two
buttons has been given that is on and
off
suppose if you click on this on button
that means we cannot create object
outside limit
suppose if I make it smaller and if I
create some object so here here I can
create the object but if I click outside
it is giving me the outside limits that
means outside the limit I cannot create
the object only within limit I can
create the object if I try something
outside so it is not taking the center
button it is giving me outside limit
that means if limits is on it will not
create the object outside the limit and
if you want to create object anywhere or
outside the limit also then you will
have to use the limit command again
limits enter and make the limits off if
you make the limits off then you can
create object anywhere
that means outside the limit area also
you can create the object so in this way
you can use limit command thank you