AutoCAD Text Command Tutorial Complete - Single Line Text; Text Size; Text

in this tutorial we will learn:about
single line text click on the arrow
below the text and select single line
then specify the start point where you
want to write the text then give the
height of the text suppose it is fine
for you and then give the rotation angle
in which angle you want to create the
text I want to create right now in zero
Degree I will give 0 enter type the text
what you want to write you can click
anywhere and continue the text writing
once text writing is done you have to
press ENTER two times to come out then
if you want to edit the text just double
click on it and you can make changes to
it and if you want to change the font of
the text then click on this annotation
and click on this textile
from here you can change the font
suppose I take this Arial black apply
clothes so it will be applied to all the
text and if you want a different font
for a particular text then again click
on textile then here you will have to
create new textile click on new give the
name to the style then ok then select
the different font what you want then
apply clothes then to apply that phone
to this text select the text and from
here click on annotation click on this
standard here and select the required
font and press escape to come out and if
you want to match textile up to
different text then you can also use the
match properties click on match property
select the source object select the
destination object press escape to come
out then if you want to change the
height of the text then for that you
will have to use the properties command
from here
we can also give properties command by
typing PR ENTER then select the text for
which you want to change the height now
here are the text properties from this
properties panel you can change the
content you can change the style
justification height from here you can
change the height of the text from here
you can change the rotation angle if you
want to use some rotation then from here
you can change the width factor height
will remain the same only length will
change if you increase that width factor
the length of text will increase and if
you decrease the factor it will be
compressed and one is the standard value
and if you want to make it italic here
you will have to use the oblique angle
as per that it will be italic and if you
- angle it will be italic in other
direction and if you want to come out
from this command press escape and close
the property panel and if you want to
read some special characters suppose I
want to write diameter then give %
percent see
if you want to write degree service 50
degree then give person percent D and if
you want to you plus and minus combined
then your % % p then click outside then
if you want to underline some text
double click it take your cursor at the
start and write % % u that will
underline the text and if you want to
end underline at some position click
there again right person % to you there
then click outside if you want to make
some text and notate you then select the
text that you want to turn into a note 8
you then from your apply the a note a to
take style and press escape the scale of
the annotated text can be controlled
from here click here and change the
scale as you change the scale the height
of the text will change as per that and
if you have some text that you want to
convert into a multi-line text suppose I
want to convert these five lines into
multi-line text then click on this
express tool select convert to M text
and select all the text and press Enter
so all this text will be converted into
multi-line and you can do formatting
from here that's all thanks for watching
we will stop here