Test: Digital Filters Round Off Effects - Electronics and Communication Engineering (ECE) MCQ

Explanation: In the realization of a digital filter, either in digital hardware or in software on a digital computer, the quantization inherent in the finite precision arithmetic operations render the system linear.

Explanation: In the recursive systems, the nonlinearities due to the finite-precision arithmetic operations often cause periodic oscillations to occur in the output even when the input sequence is zero or some non zero constant value.

Explanation: In the recursive systems, the nonlinearities due to the finite-precision arithmetic operations often cause periodic oscillations to occur in the output even when the input sequence is zero or some non zero constant value. The oscillations thus produced in the output are known as ‘limit cycles’.

Explanation: The oscillations in the output of the recursive system are called as limit cycles and are directly attributable to round-off errors in multiplication and overflow errors in addition.

Explanation: The amplitudes of the output during a limit circle are confined to a range of values that is called the ‘dead band’ of the filter.

Explanation: When the input sequence x(n) to the filter becomes zero, the output of the filter then, after a number of iterations, enters into the limit cycle. The output remains in the limit cycle until another input of sufficient size is applied that drives the system out of the limit cycle. Similarly, zero input limit cycles occur from non-zero initial conditions with the input x(n)=0.

Explanation: We note that when the response of the single pole filter is in the limit cycle, the actual non-linear system acts as an equivalent linear system with a pole at z=1 when the pole is positive and z=-1 when the poles is negative.

Explanation: We know that

Given |a|=1/2 and b=4 => |v(n-1)| ≤ 1/16=> The dead band is (-1/16,1/16).

Explanation: There is an possible limit cycle mode with zero input, which occurs as a result of rounding the multiplications, corresponds to an equivalent second order system with poles at z=±1. In this case the two pole filter exhibits oscillations with an amplitude that falls in the dead band bounded by 2-b/(1-|a1|-a2).

Explanation: It can be easily shown that a necessary and sufficient condition for ensuring that no zero-input overflow limit cycles occur is |a1|+|a2|<1
which is extremely restrictive and hence an unreasonable constraint to impose on any second order section.