Test: Phase Controlled Rectifiers - 1


Test Description

10 Questions MCQ Test GATE Electrical Engineering (EE) 2023 Mock Test Series | Test: Phase Controlled Rectifiers - 1

Test: Phase Controlled Rectifiers - 1 for Electrical Engineering (EE) 2022 is part of GATE Electrical Engineering (EE) 2023 Mock Test Series preparation. The Test: Phase Controlled Rectifiers - 1 questions and answers have been prepared according to the Electrical Engineering (EE) exam syllabus.The Test: Phase Controlled Rectifiers - 1 MCQs are made for Electrical Engineering (EE) 2022 Exam. Find important definitions, questions, notes, meanings, examples, exercises, MCQs and online tests for Test: Phase Controlled Rectifiers - 1 below.
Solutions of Test: Phase Controlled Rectifiers - 1 questions in English are available as part of our GATE Electrical Engineering (EE) 2023 Mock Test Series for Electrical Engineering (EE) & Test: Phase Controlled Rectifiers - 1 solutions in Hindi for GATE Electrical Engineering (EE) 2023 Mock Test Series course. Download more important topics, notes, lectures and mock test series for Electrical Engineering (EE) Exam by signing up for free. Attempt Test: Phase Controlled Rectifiers - 1 | 10 questions in 30 minutes | Mock test for Electrical Engineering (EE) preparation | Free important questions MCQ to study GATE Electrical Engineering (EE) 2023 Mock Test Series for Electrical Engineering (EE) Exam | Download free PDF with solutions
1 Crore+ students have signed up on EduRev. Have you?
Test: Phase Controlled Rectifiers - 1 - Question 1

In an SCR half wave rectifier, the forward breakdown voltage of SCR is 110 V for a gate current of 1 mA. If a 50 Hz sinusoidal voltage of 220 V peak is applied, the time during which SCR remains OFF would be equal to (assume load resistance is 100 Ω and the holding current to be zero)

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 1


Test: Phase Controlled Rectifiers - 1 - Question 2

When an SCR full wave rectifier is connected across a sinusoidal voltage of 400 sin 314t, the RMS value of the current flowing through the device is 20 A. The power rating of the SCR is

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 2

As the supply voltage is 400 sin 314t
Vm = 400 V,
Peak invesre voltage (PIV)

RMS value of current = 20 A 
Average value of current,

Test: Phase Controlled Rectifiers - 1 - Question 3

Assertion (A): Single phase half-wave converter introduces a dc component into the supply line.
Reason (R) : The supply current taken from the source is unidirectional and is in the form of dc pulses

Test: Phase Controlled Rectifiers - 1 - Question 4

Assertion (A) : By using freewheeling diode, load performance becomes better.
Reason ( R ) : Freewheeling diode prevents the load voltage from becoming negative.

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 4

By using freewheeling diode, load performance becomes better because load current waveform is improved.
Whenever load voltage tends to go negative, freewheeling comes into play as a result of which ioaa current is transferred from main thyristor to freewheeling diode, allowing the thyristor to regain its forward blocking capability.
Hence, both assertion and reason are true but reason is not the correct explanation of assertion.

Test: Phase Controlled Rectifiers - 1 - Question 5

The advantage of using a freewheeling diode with bridge type ac to dc converter is

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 5

Power delivered to the load, for the same firing angle is more when freewheeling diode is used As volt-ampere input is almost the same witt and without a freewheeling diode, therefore the input power factor with use of freewheeling diode is improved.

Test: Phase Controlled Rectifiers - 1 - Question 6

A single-phase full converter is connected across 230 V ac. Its average output voltage when firing angle is 30° is approximately equal to

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 6

The average output voltage for a single-phase full converter is

Test: Phase Controlled Rectifiers - 1 - Question 7

SCRs with peak forward rating of 1 kV and average on-state current rating of 40 A is used in single-phase mid-point converter. If the factor of safety is 2.5, then the power that this converter can handle is

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 7

Maximum voltage across SCR in single-phase mid-point converter is 2Vm. Therefore, this converter can be design for a maximum voltage of

∴ Maximum average power that the mid-point converter can handle is

Test: Phase Controlled Rectifiers - 1 - Question 8

The main advantages of the dual converter with circulating current operation is/are
1. the efficiency and power factor are more.
2. it has faster operation than dual converter without circulating current.
3. the thyristors are rated for lower current.

Choose the correct code from the following

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 8

Circulating current gives rise to more losses in the converters, hence the efficiency and power factor are low. Thus, statement-1 is false.
In a non-circulating current type dual converter, the normal delay period of 10 to 20 ms is required while no delay period is required in circulating current type dual converter. Therefore, circulating current type dual converter is faster than non-circulating type dual converter. Thus, statement-2 is true.
As the dual converter with circulating current has to handle load current as well as circulating currents, therefore the thyristors are rated for higher currents. Hence statement-3 is false.

Test: Phase Controlled Rectifiers - 1 - Question 9

 The average value of voltage of a single-phase ac voltage converter with resistive load is (α is the firing angle).

Test: Phase Controlled Rectifiers - 1 - Question 10

A four quadrant operation requires

Detailed Solution for Test: Phase Controlled Rectifiers - 1 - Question 10

In case “four quadrant operation" is required without any mechanical changeover switch, two full converters can be connected back to back to the load circuit. Such an arrangement using two converters in antiparailel and connected to the same dc load is called a “dual converter."

Use Code STAYHOME200 and get INR 200 additional OFF
Use Coupon Code
Information about Test: Phase Controlled Rectifiers - 1 Page
In this test you can find the Exam questions for Test: Phase Controlled Rectifiers - 1 solved & explained in the simplest way possible. Besides giving Questions and answers for Test: Phase Controlled Rectifiers - 1, EduRev gives you an ample number of Online tests for practice