Technical Mock Test CE (SSC JE)- 4

Rise of water table above the ground surface causes

In a beam and slab structure, if width of beam is b_w, depth of slab D_f, lo is the distance between points of zero moments in the beam, effective width of intermediate flange is given by

Physical properties which influence permeability are

Phreatic line in an earthen dam is

Time factor for a clay layer is

Passive earth pressure in a soil mass is proportional to

A soil having particles of nearly the same size isknown as:

Which of the following have an influence on the value of permeability?
1. void ratio
2. degree of saturation
3. pressure head
4. grain size

Select the correct answer using the codes given below:

Match List I with List II and select the correct answer using the codes given below the lists:

Given that , the depth of tension crack developing in a cohesivesoil backfill would be

The main principle of surveying is to work

Vertical component of shear resisted by stirrups inclined at α to vertical in a R.C. beam is

The correction to be applied to each 30 metre chain length along θ slope , is

The line normal to the plumb line is known as

In levelling operation

The staff intercept will be

If i is the stadia distance, f is the focal length andd is the distance between the objective andvertical axis of the techeometer, the multiplying constant is

Planimeter is used for measuring

Match List-I with List-II and choose a correct answer by using the codes given below the lists:

A point determined by resection on a plane tableis called:

Nagpur road plan fomulae watch prepared byassuming

The shape of the camber, best suited for cementconcrete pavements, is

Desire lines are plotted in

The maximum width of a vehicle asrecommended by IRC is

For highway geometric design purposes thespeed used is

Traffic volume is equal to

Maximum number of vehicles can be parked with

Bitumen of grade 80/100 means

Flexible pavement distribute the wheel load

Match List-I with List-II and choose a correct answer by using the codes given below the lists:

Rapid curing cut back bitumen is produced by blending bitumen with

The rail is designated by its

The standard length of rail for Broad Gauge andMetre Gauge are respectively

The side slope of embankments for a railwaytrack is generally taken as

Creep is the

an isochrone is line on the basin map

An accurate estimate of average rainfall in aparticular catchment area can be obtained by

Which one of the following defines Aridity index (AI) ?

The discharge per unit drawdown at the well isknown as

What is 'Hydrological Cycle' ?

The double mass curve technique is used:

Match List–I with List–II and select the correct answer using the codes given below the lists:

Consider the following chemical emulsions:
1. Methyl alcohol
2. Cetyl alcohol
3. Stearyl alcohol
4. Kerosene
Which of the above chemical emulsions is/are used to minimize the loss of water through the
process of evaporation?

Match List-I (Name of scientists) with List-II (Contribution to field of hydrology) and select
the correct answer using the codes given below the lists:

In the design of isolated column footing, ofthickness d the critical section from theconsideration of single shear is

Ombrometer (pluviometer) is used to measure

As per IS : 800, the maximum deflection in a beam should not exceed

Bending compressive and tensile stressesrespectively are calculated based on

If the thickness of thinnest outside plate is 10mm, then the maximum pitch of rivets in tensionwill be taken as

As per IS : 800, the thickness of slab base is given by

Which of the following types of riveted joint isfree from bending stresses?

As compared to field rivets, the shop rivets are

In the cross-section of a weld, throat is the

Rocks formed due to alteration of originalstructure due to heat and excessive pressure,arecalled

If P is the percentage of water required fornormal consistency, water to be added fordetermination of initial setting time, is

Minimum required watwer cement ratio for aworkable concrete, is

Most commonly used solvent in oil paints, is

Turpentine oil is used in paints as

The commonly used thinner in oil paints, is

Oil varnish generally consists of

Match List-I with List-II and select the correct answer using the codes given below the lists:

IS code recommends that the slope of stairs should be between

Quick lime (or caustic lime)

Pick up the compound responsible for earlystrength of cement from the following

If water required for 1 bag of cement is 30 litres,the water cement ratio is :

Match List-I with List-II and select the correct answer using the codes given below the lists:

Pick up the timber from the following which isused for railway sleepers:

Which eccentric load, if placed within the central core shown in figures below, does not produce
tension in the column cross-section?

Limiting value of depth of neutral axis in R.C.beam od depth d with Fe 415 steel is

For the above cantilever beam, the absolute value of shear force at A is

IS 456 – 2000 recommends that in any columnreinforcement shal not be more than

0.2 per cent proof stress means

Endurance limit is

A strain gauge consists of a group of _______rosetts.

Match List I with List II and select the correct answer using the codes given below the lists:

Water obtained from _____ is generally knownas sub-surface water.

Which of the following is used for computing thequantity of water for fire demand?

Spacing of longitudinal bars measured along theperiphery of R.C. column shall not exceed

Aeration is carried out to

Floatation is a method of water purification by

In fill and draw type of sedimentation tanks thetime required for one cycle is

The most common and universal coagulant usedin water works is

What indicates the permanent hardness when alum is added to water?

Which one of the following is not a method ofdesalination ?

Which one of the following layout of waterdistribution system is known as interlacedsystem?

Minimum pitch of rivets shall not be less than 

Sewer lines are designed for a design period of

An egg-shaped section of sewer

Manholes are generally located at

Match List-I (Equipment) with List-II (Parameter) and select the correct answer using
the codes given below the lists:

Figure shows a typical interaction curve for column design. Match List-I with List-II

The most suitable solid waste disposal methodfor rural areas is

Match List–I with List–II and select the correct answer using the codes given below the lists:

Which one of the following pairs is not correctly matched?

Match List–I with List–II and select the correct answer using the codes given below the lists:
List–I
a. Vertical Cliff
b. Steep slope
c. Hill
d. Overhanging cliff
 

LIST – II
1. Contour lines of different elevations unite to form one line
2. Contour lines of different elevations cross one another
3. Contour lines are closely spaced
4. Closed contour lines with higher values inside them

Match List–I (Terms) with List–II (Description) and select the correct answer using the codes
given below the lists:
 

List–I
a. Contour
b. Line of collimation
c. Tie line
d. Magnetic meridian
 

LIST – II
1. Line joining magnetic North and South
2. Line joining subsidiary station on the main line
3. Line joining points of same elevation
4. Line joining optical centre of the objective lens with point of intersection of cross-wires

Cavitation takes place if the pressure of the fluidflowing at any point is