Test: Fits & Tolerance - 1


10 Questions MCQ Test Topicwise Question Bank for Mechanical Engineering | Test: Fits & Tolerance - 1


Description
This mock test of Test: Fits & Tolerance - 1 for Mechanical Engineering helps you for every Mechanical Engineering entrance exam. This contains 10 Multiple Choice Questions for Mechanical Engineering Test: Fits & Tolerance - 1 (mcq) to study with solutions a complete question bank. The solved questions answers in this Test: Fits & Tolerance - 1 quiz give you a good mix of easy questions and tough questions. Mechanical Engineering students definitely take this Test: Fits & Tolerance - 1 exercise for a better result in the exam. You can find other Test: Fits & Tolerance - 1 extra questions, long questions & short questions for Mechanical Engineering on EduRev as well by searching above.
QUESTION: 1

The term '‘Allowance1’ in limits and fits is usually referred to

Solution:
QUESTION: 2

Which of the following is the correct way of designating fit

Solution:
QUESTION: 3

Drilled holes and honed holes could be designated by following grades respectively

Solution:
QUESTION: 4

Newall system of limits and fits is the oldest system working on hole basis system. The grades of holes and shafts specified respectively are

Solution:
QUESTION: 5

ISA tolerance system consists of following numbers of qualities of tolerance, and grades of fit respectively

Solution:
QUESTION: 6

The geometric tolerance that does not need a datum for fits specification is

Solution:

Concentricity, run out and perpendicularity are all measured with respect to some reference datum line
Flatness needs not any reference (or) datum line

QUESTION: 7

In limits and fits system, basic shaft system is one whose

Solution:
QUESTION: 8

Surface roughness on a drawing is represented by

Solution:
QUESTION: 9

 Tolerance on the dimension x in the two component assembly shown below is

Solution:

For equal bilateral tolerances, the tolerance of the gap is

QUESTION: 10

For grade IT7, value of tolerance is equal to

Solution:

Similar Content

Related tests