NEET Exam  >  NEET Notes  >  Physics Class 12  >  Modulation and Wave Propagation

Modulation and Wave Propagation | Physics Class 12 - NEET PDF Download

Modulation

The process of superimposing the audio signal over a high frequency carrier wave is called modulation.

In the process of modulation anyone characteristic of carrier wave is varied in accordance with the instantaneous value of audio signal (modulating signal).

Need of Modulation

(i) Energy carried by low frequency audio waves (20 Hz to 20000 Hz) is very small.

(ii) For efficient radiation and reception of signal. the transmitting and receiving antennas should be very high approximately 5000 m.

(iii) The frequency range of audio signal is so small that overlapping of signals create a confusion.

Types of Modulation

(i) Amplitude Modulation In this type of modulation, the amplitude of high frequency carrier wave is varied in accordance to instantaneous amplitude of modulating signal.

Bandwidth required for amplitude modulation= twice the frequency of the modulating signal.

(ii) Frequency Modulation In this type of modulation, the frequency of high frequency carrier wave is varied in accordance to instantaneous frequency of modulating signal

(iii) Pulse Modulation In this type of modulation, the continuous waveforms are sampled at regular intervals. Information is transmitted only at the sampling times

Demodulation

The process of separating of audio signal from modulated signal is called demodulation.

Antenna

An antenna converts electrical energy into electromagnetic waves at transmitting end and pick up transmitted signal at receiving end and converts electromagnetic waves into electrical signal.

Modem

The term modem is contraction of the term modulator and demodulator. Modem is a device which can modulate as well as demodulate the signal. It connect one computer to another through ordinary telephone lines.

Fax (Facsimile Telegraphy)

The electronic reproduction of a document at a distant place is called FAX

Radio Waves

The radio waves are the electromagnetic waves of frequency ranging from 500 kHz to about 1000 MHz. These waves are used In the field of radio communication. With reference to the frequency range and wavelength range, the radio waves have been divided into various categories shown in table.

Frequency Range and Wavelength Range of Radio Waves

 

S.No.

Frequency

band

Frequency range

Wavelength range

 

Main Use

1.

Very-Low

Frequency

(VLF)

3 kHz to 30 kHz

10 km to 100 km

Long distance point to  point

 communication

2.

Low Frequency (LF)

30 kHz to 300 kHz

1 km to 10 km

Marine                and

navigational purposes

3.

Medium

Frequency

(MF)

300 kHz to 3 MHz

100 m to 1 km

Marine                and

broadcasting

purposes

4.

High

Frequency

(HF)

3 MHz to 30 MHz

10 m to 100 m

Communication of all types

5.

Very-High

Frequency

(VHF)

30 MHz to 300

MHz

1 m to 10 m

T V Radar and air navigation

6.

Ultra-High Frequency

(UHF)

300 MHz to 3000 MHz

10 cm to 1 m

Radar                 and

microwave

communication

7.

Super-High-Frequency (SHF)

3 GHz to 30 GHz

1 cm to 10 cm

Radar, Radio relays and                navigation

purposes

8.

Extremely-High Frequency (EHF)

30 GHz to 300 GHz

1 mm to 1 cm

Optical              fibre

communication

 

Propagation of Radio Waves

The three modes are discussed below.


(i) Ground Wave or Surface Wave Propagation It is suitable for low and medium frequency up to 2 MHz. It is used for local broad casting.

Modulation and Wave Propagation | Physics Class 12 - NEET


(ii) Sky Wave Propagation It is suitable for radio waves of frequency between 2 MHz to 30 MHz. It is used for long distance radio communication.

Modulation and Wave Propagation | Physics Class 12 - NEET


Critical Frequency The highest frequency of radio wave that can be reflected back by the ionosphere is called critical frequency.

Critical frequency, vc = 9 (Nmax)1 / 2

Where, Nmax = number density of electrons/metre3.


Skip Distance The minimum distance from the transmitter at which a sky wave of a frequency but not more than critical frequency, is sent back to the earth.

Skip distance (Dskip) = 2h (Vmax / Vc)2 – 1

where h is height of reflecting layer of atmosphere,

Vmax is maximum frequency of electromagnetic waves and Vc is critical frequency.

Fading The variation in the strength of a signal at receiver due to interference of waves, is called fading.

(iii) Space Wave Propagation It is suitable for 30 MHz to 300 MHz. It is used in television communication and radar communication. It is also called line of sight communication.

Modulation and Wave Propagation | Physics Class 12 - NEET

  • Range is limited due to curvature of earth. If h be the height of the transmitting antenna, then signal can be received upto a maximum distance

d = √2RH

  • If height of transmitting and receiving antennas be hT and hR respectively. The effective range will

Modulation and Wave Propagation | Physics Class 12 - NEET

Microwave Propagation

  • Microwaves are electromagnetic wave of frequency 1 to 300 GHz, greater than those of TV signals. The wavelength of microwaves is of the order of a few mm.
  • Microwave communication is used in radar to locate the flying objects In space.
  • These waves can be transmitted as beam signals in a particular direction, much better than radiowave,
  • There is no diffraction of microwave around corners of an obstacle which happens to lie along its passage.

Satellite Communication

It IS carried out between a transmitter and a receiver through a satellite. A geostationary satellite is utilized for this purpose, whose time period is 24 hours.

A communication satellite is a space craft, provided with microwave receiver and transmitter. It is placed in an orbit around the earth. The India remote sensing satellites are

IRS-IA, IRS-IB and IRS-IC

The line-of-sight microwave communication through satellite is possible if the communication satellite is always at a fixed location with respect to the earth, e.g., the satellite which is acting as a repeater must be at rest with respect to the earth. It is so far a satellite known as geo-stationary satellite.

The basic requirements for geostationary satellites are as follows:

  1. The time period of revolution of the satellite around the earth is equal to the time period of rotation of earth about its polar axis i.e., 24 h.
  2. The sense of revolution of the satellite around the earth is the same as that of the earth about its polar axis i.e., from west to east.
  3. The orbital plane of revolution of satellite is concentric and coplanar with the equatorial plane of earth.
  4. The height of geostationary satellite above the equator of earth is nearly 36000 km and its orbital velocity is nearly 3.1 km/s.

The orbit in which the gee-satellite above revolves around the earth is known as geo-synchronous orbit. As its angular speed is synchronized with the angular speed of the earth. therefore, the geo-stationary satellite is also known as geo-synchronous satellite.

Merits of Satellites Communication

  1. The satellite communication covers wide area for broadcasting a8 compared to other communication systems i.e. it has wide coverage range.
  2. The satellite communication is also used effectively in mobile communication.
  3. The satellite communication is found to be much economical as compared to other communication systems on earth. Infact. the cost involved in satellite communication is independent of the distance.
  4. The satellite communication is most cost effective in remote and hilly areas, such as Ladakh, Himachal Pradesh etc.
  5. The satellite communication permits transmission of data at rate.
  6. The satellite communication is very accurate and economical search. rescue and navigation purposes.

Demerits of Satellite Communication

1. If a system on the satellite goes out of order due to environmental stresses, it is almost impossible to repair it.

2. In satellite communication, there is a time delay between transmission and reception, due to extremely large communication path length (greater than 2 x 36000 km). This delay causes a time gap during talking, which proves quite annoying.

Remote Sensing

It is a technique of observing or measuring the characteristics of the object at a distance. A polar satellite is utilized for this purpose.

Distance upto which a signal can be obtained from an antenna is given by

d = √2hR

where, h is height of antenna and R is radius of earth.

LED and Diode Laser in Communication

Light Emitting. Diode (LED) and diode laser are preferred sources for optical communication links to the following features.

  1. Each produces light of suitable power required in optical communication. Diode laser provides light which is monochromatic and coherent. This light is obtained as a parallel beam. It is used in very long distance transmission.
  2. LED provides almost monochromatics light. This suitable for small distance transmission. It is infact, a low cost device as compared to diode lasers.

Line Communication

  • Transmission lines are used to interconnect points separated from each other. For example interconnection between a transmitter and a receiver or a transmitter and antenna or an antenna and a receiver are achieved through transmission lines.
  • Line communication may be in the form of electrical signal or optical signal.

Optical Fibres

An optical fibre is a long thread consisting of a central core of glass or plastic of uniform refractive index. It is surrounded by a cladding of material of refractive index less than that of the core and a protective Jacket of insulating material.

There are three types of optical fibre configuration

  1. Single mode step index fibre
  2. Multi mode step index fibre
  3. Multi mode graded index fibre.

Modulation and Wave Propagation | Physics Class 12 - NEET


Applications of Optical Fibres

  1. A bundle of optical fibres is called light pipe. This pipe can transmit as image. Since the pipe is flexible, it can be twisted in any desired manner. Hence it is used medical and optical examination of even the inaccessible parts of human body, e.g., in endoscopy.
  2. Optical fibres are used in transmission and reception of electrical signals by coverting them first into light signals.
  3. Optical fibres are used in telephone and other transmitting cables. Each fibre can carry upto 2000 telephone messages without much loss of intensity.
The document Modulation and Wave Propagation | Physics Class 12 - NEET is a part of the NEET Course Physics Class 12.
All you need of NEET at this link: NEET
98 videos|387 docs|104 tests

Top Courses for NEET

FAQs on Modulation and Wave Propagation - Physics Class 12 - NEET

1. What is modulation and how does it relate to wave propagation?
Ans. Modulation is the process of modifying a carrier wave (usually a high-frequency wave) with a signal to transmit information. It is used to transfer the signal over long distances by converting it into a form that can travel through the transmission medium. Wave propagation refers to the manner in which waves travel through a medium. Modulation is necessary for efficient wave propagation because it allows the signal to be transmitted over long distances without significant loss or distortion.
2. What are the different types of modulation techniques?
Ans. There are several types of modulation techniques used in communication systems. These include amplitude modulation (AM), frequency modulation (FM), phase modulation (PM), and quadrature amplitude modulation (QAM). Each technique has its own advantages and is used in various applications depending on factors such as bandwidth requirements, signal quality, and data transmission rates.
3. How does amplitude modulation (AM) work?
Ans. Amplitude modulation (AM) is a modulation technique where the amplitude of the carrier wave is varied in proportion to the waveform being transmitted. The audio signal, which is the information to be transmitted, is added to the carrier wave. The resulting waveform has varying amplitude, representing the audio signal. At the receiver, the carrier wave is removed, leaving behind the original audio signal.
4. What is wave propagation and why is it important in wireless communication?
Ans. Wave propagation refers to the way in which electromagnetic waves travel through a medium or space. In wireless communication, it is crucial because it determines how well the signal can reach the intended receiver. Understanding wave propagation helps in designing and optimizing wireless communication systems, ensuring reliable signal transmission and reception. Factors such as interference, obstacles, distance, and frequency affect wave propagation and can impact the quality and strength of the received signal.
5. What are the challenges in wave propagation for wireless communication?
Ans. Wave propagation in wireless communication faces various challenges. One major challenge is signal attenuation, where the signal strength decreases as it travels through the medium or encounters obstacles. Diffraction, reflection, and scattering can also cause signal distortion and multipath propagation, where multiple copies of the signal arrive at the receiver with different delays. Interference from other devices or signals can further degrade the quality of the received signal. These challenges need to be considered and mitigated in wireless communication system design.
98 videos|387 docs|104 tests
Download as PDF
Explore Courses for NEET exam

Top Courses for NEET

Signup for Free!
Signup to see your scores go up within 7 days! Learn & Practice with 1000+ FREE Notes, Videos & Tests.
10M+ students study on EduRev
Related Searches

Objective type Questions

,

Semester Notes

,

mock tests for examination

,

pdf

,

study material

,

Modulation and Wave Propagation | Physics Class 12 - NEET

,

shortcuts and tricks

,

Important questions

,

video lectures

,

Previous Year Questions with Solutions

,

Sample Paper

,

past year papers

,

MCQs

,

Exam

,

Viva Questions

,

ppt

,

Extra Questions

,

practice quizzes

,

Free

,

Modulation and Wave Propagation | Physics Class 12 - NEET

,

Summary

,

Modulation and Wave Propagation | Physics Class 12 - NEET

;