The rate of movement of charge through any conductor is known as
1 Crore+ students have signed up on EduRev. Have you? Download the App |
Three resistance of values 8 ohms, 12 ohms and 24 ohms are connected in parallel across12 volts supply, the total resistance of the circuit will be
The sure test of electrification is
The suspectance (b) of a branch can be determined by
106.The accuracy of M.C. instrument as compared to M.I. instruments is –
Which of the following advantage, the dynamometer watt meter has ?
In case of two phase supply the electrical displacement of the winding is –
Synchronising (parallel operation) of three phase alternator as compared to single phase alternator is –
The controlling torque can be produced by –
The generator which gives d.c. supply to the rotor is called –
Under no load running condition the angle between induced voltage and supply voltage willbe –
One foot angular is equal to –
For welding of sheets which type of welding is recommended –
The spot welding machine can be used for welding sheets of thickness –
In which of the following places 70 MW gas turbine power plant being operated as base load plant ?
The solar or photo voltaic cell converts
The efficiency of solar cell is about
The main source (s) of production of biogas is / are
Which of the following plants will take least time in starting from cold conditions to full-load operation ?
Shunt capacitors in a substation
The unit of transmission loss coefficient is
The permissible variation of frequency in power system is
Generators for base load plants are usually designed for maximum efficiency around
Two -insulator discs of identical capacitance value C makes up a string for a 22 kV, 50 Hz,single-phase overhead line insulation system. If the pin to earth capacitance is also C, then the string efficiency is
The knowledge of diversity factor helps in computing
The load duration curve for a power station is as shown in the given figure. The reserve capacity in the plant at 70% capacity factor is
Flat rate tariff can be charged on the basis of
)
The low power factor of an industrial plant is uneconomical for
Consider the following materials for line conductors :
1. Hard drawn copper
2. Cadmium copper
3. Aluminium
4. Galvanised steel
The correct sequence of the descending order of their electrical conductivities is