0203 Blender What angle test results Video Lecture | Learn 3D Modelling: The Ultimate Blender Guide - Software Development

alright so let's take a look at those
results this is the one with the fan and
this is the one without the fan as you
can see you know towards the bottom of
the print ad no Kate I'm same with this
one I had an okay time printing those
but as it went up heat gained and had no
way to cool off and it got worse and
worse and worse in fact if you chose to
just print this one at a time and this
one at a time this is what it would look
like in that case scenario so let's just
say I printed just this one so not as
bad because the head wasn't traveling
back and forth you don't have the wave
marks that this one has right here but
because it didn't have time to cool
whatsoever this is what it would look
like if you printed this one all by
itself Wow right so fans are important
so in this one I have the fans and I'm
suffering from another problem and you
can see that right here where it's it's
not being filled in okay not being
filled in well in the last chapter we
looked at what we could do to remedy
that was instead of like a point five
you 0.45 setting
okay so let's look at what that looks
like and there's the one print it that
way and here's the one printed this way
perfect right now why print one this way
and one that way what was that well if
you look at the grain of the plastic if
I was to add any kind of like physical
damage to this just by just pressing it
down hard enough you know it could bust
I doubt it it's really strong actually
I'm putting as much pressure as i can on
there and i still have no way of
breaking it but look at this part since
everything's going this way it's super
strong absolutely no way of breaking
that whatsoever unless you used a hammer
but physically pressing down on it with
all your might it's it's really it would
be really hard to break that so that's
the difference you have to learn when to
print vertical window print horizontal
you'll also have to know when to put a
fan on it and when not to put a fan on
it and you also have to could consider
you know grain of plastic what makes it
stronger part all right so you should
probably print this you know taking go
rip it again at point four or five and
print it and then give me all those
that's what I want as it turn in I want
a little bag filled with your little
test items and you can keep them after
you're done but I just want to I want to
see what you did how they turned out and
then I'll hand them right back and mark
you off with for the point all right so
enjoy and on to the next chapter where
we look at another concept