0403 Slic3r Results 1 Video Lecture | Learn 3D Modelling: The Ultimate Blender Guide - Software Development

alright so here's the blind stab in the
dark right now I have a piece that has a
really thin base and any time that I'm
bridging something like this where I
have a technical opening that has no
support structure I'll always print a
base also I told you to turn the fan on
low look what happened okay look at the
goop on the top it didn't have enough
time and keep in mind this is a very
small piece okay so it did not have
enough time to cool in this general
location all right now what we're going
to do is keep printing this until it
improves so much that it's perfect how
would I go about doing that well let's
go back to the actual slicing program
okay let's go to slicer for smaller
pieces like this let's say there's just
one of them so it doesn't have enough
time to cool we could do a few things
one we could turn the fan up on high
that helps and then another thing we
could do is go to filament and see where
the temperature is 230 okay for smaller
pieces that are singled let's try to 20
lowing the degrees down to ten points
okay good keep continuing with the point
four or five for the thin wall and this
time I'm going to wait for the first two
layers and then turn the fan on alright
so let's export that
good now what I'm going to do is hit
print and run in the other room and
spray down the printer with hairspray
for each time that I do pray and I make
sure I stay in the bed just a little bit
and then spray it with hairspray as you
know if you were in the class so that's
one of the things alright so I'll see
you in the next video where we look at
the results