0404 Slic3r Results 2 Video Lecture | Learn 3D Modelling: The Ultimate Blender Guide - Software Development

alright so I'm going to display this on
a black surface you're going to see some
noise here but that's just the video so
here's our second part and this time you
could tell it is much better as far as
how clean it goes all the way up now
when you lower the temperature sometimes
you're going to get these little things
these little teeny tiny hairs that show
up between bridges that's pretty normal
so here's the part before and you can
see how wavy it is introdu all the way
down it's got some slack going right
here in this area from the bridge but
this is really kind of burnt you can
look at the sphere on the top definitely
no detail at the very top this one's
starting to get detail all right now
this is incredibly small piece so it's a
pretty good challenge to try to print
something like this so here's what we're
going to do because it never has enough
time to cool even with the fan on high
and it's such a small piece we're going
to actually print two of these so we'll
have more and we're going to set this
one over here and this one over here ok
so these incredibly small pieces like
this it is probably good to combine them
with other pieces before you print them
but if you have no choice and they are
small you know sometimes it's better to
have too here's the reason why so the
printer head has to go from here to here
and by the time it goes from there to
there it has time to cool another thing
I like to do is this
ok so I'll set them offset from each
other and the reason for that is because
as the printer goes back and forth it
has to go over and then down or across
to get to this piece it cannot go
straight across therefore it does give
it a couple extra seconds to cool so
we're going to try this method right
here and we're going to have a fan so I
have my fan when it kind of this way so
therefore I'm going to have this setup
like this and just like that okay since
my fan is pointing kind of kiddy corner
to this side alright let's export that
same heat setting same everything else
fans going to be set on high and let's
look at the results for that in the next
video