SolidWorks 2014 Surface Tutorial 71: Swept and Twist surface Video Lecture | SolidWorks: Essential Training (All Commands included) - IT & Software

tutorial number 71 in this story we're
going to talk about the next
so after stood the extrude or swept
surface it is not activated here so
let's start some sketches to make a
sweep let's stop this profile and
try to find another profile to be
perpendicular to that profile in order
to swim we have to plan make an a spline
so here you can decide shaped off sweep
let's succeed
now you notice the slip surface is
activated we have two surfaces the
profile on the path
so let's activate this way the profile
is here selected to be bad so it's not
the right selection so you select sketch
one as profile the path would be this so
no don't click ok so this is the very
simple syrup choice and you can try to
edit let's see the different options so
here you have fully part so it will be a
very simple sleeping and you have keep
normal constant so it will the profile
will continue being constant the whole
sweeping way so click OK
so you see the different twink exit Oh
Eddy here you can also twist along path
so here you can see the twisting you are
increasing so we can make it 90 degree
or speak an angle
here you can be warned the twisting
direction let's fill it again
the hair you are twist along with the
Nova Coniston strike right degree and
let's start to make another option or
another trick with this twisting if you
go to edit Phillipa you have twists
along the path and you have either two
liquid degrees or with turns whichever
if you can select turns five turns click
ok so you are twisting and making this
special roll
so there are many options to do to
create your almost any shape you want on
so it works