SolidWorks 2014 Surface Tutorial 91: Split Line Video Lecture | SolidWorks: Essential Training (All Commands included) - IT & Software

the next tool set and the surfaces to
books is the references we already
talked about the plane and coordinate
system and so on they are the same or
the ones we used before we're in the
features menu the reference geometry so
now let's move to the next menu the
curves or these menu this allow you to
further advance or with your surfaces
the story going to talk about the split
line so split line you are able to
create a sketch spline or line and from
that sketch you can split your surface
let's try to make a sketch on a plane
that is where we are going to cut that
surface so this case the front plane
let's start to sketch normal to just
create a line cutting line or deny then
you are done so we are done with this
line you can add dimensions and so on go
to a split line so it's activated here
selected and here your
becomes sketch this line the surfaces
where you are going to split this
surface you are done click OK so this
line is moved like knife through that
surface and splitted into two parts so
now you are able to war with one put
this all alone you can delete that
surface or trim it