The settlement analysis for a clay layer draining from top and bottom shows a settlement of 2.5 cm in 4 years and an ultimate settlement of 10 cm. However, detailed subsurface investigation reveals that there is non drainage at the bottom. The ultimate settlement in this condition will be ______ cm.Correct answer is '10'. Can you explain this answer?

Question

Answer

The ultimate settlement is independent of drainage path. Decrease in Drainage path can only increase the rate of settlement thus decrease the time taken by soil sample to settle. Ultimate settlement Is only dependent on soil type.

Answer

Tyuu

Answer

If we change the system of consolidation from 2way drainage to 1way drainage the time required for attain ultimate settlements in 1-way drainage system is increases 4times of time required in 2-way drainage system.but the magnitude of ultimate settlements is same in the both systems.ultimate settlements are depends upon only soil.

Answer

Settlement Analysis for a Clay Layer with Drainage at Top and Bottom

Given Information:
- Settlement after 4 years: 2.5 cm
- Ultimate settlement: 10 cm
- Detailed subsurface investigation reveals non-drainage at the bottom

Explanation:

1. Settlement Analysis
- Settlement analysis is performed to estimate the vertical displacement or settlement that occurs in a soil layer due to various factors such as loading, consolidation, and creep.
- It is typically done for clay layers, as clay has high compressibility and undergoes significant settlement over time.

2. Settlement due to Drainage
- When a clay layer is subjected to drainage from both the top and bottom, the excess pore water pressure generated during loading is dissipated, allowing the clay to consolidate and settle over time.
- The settlement due to drainage is typically larger in the initial years and gradually decreases over time.
- In this case, the settlement after 4 years is 2.5 cm, indicating that the clay layer has settled to a certain extent due to drainage.

3. Ultimate Settlement
- The ultimate settlement is the maximum settlement that a clay layer can undergo under a given loading condition.
- It represents the long-term settlement after complete consolidation of the clay layer.
- In this case, the ultimate settlement is given as 10 cm.

4. Non-Drainage at the Bottom
- The detailed subsurface investigation reveals that there is non-drainage at the bottom of the clay layer.
- Non-drainage at the bottom means that the excess pore water pressure generated during loading cannot dissipate freely, resulting in reduced consolidation and settlement.

5. Effect of Non-Drainage
- When there is non-drainage at the bottom, the settlement of the clay layer is restricted compared to the condition where drainage is present at both the top and bottom.
- The excess pore water pressure generated during loading cannot dissipate fully, leading to a lower rate of consolidation and settlement.
- Therefore, the ultimate settlement under non-drainage conditions will be less than the ultimate settlement under drainage conditions.

6. Conclusion
- Based on the given information, the ultimate settlement in the condition of non-drainage at the bottom is still specified as 10 cm.
- This implies that even though there is non-drainage at the bottom, the clay layer will settle to the same extent as in the drainage condition after complete consolidation.
- It suggests that the non-drainage at the bottom does not significantly affect the ultimate settlement of the clay layer in this particular case.

Similar Civil Engineering (CE) Doubts

The settlement analysis for a clay layer draining from top and bottom shows a settlement of 2.5 cm in 4 years and an ultimate settlement of 10 cm. However detailed subsurface investigation reveals that there is no drainage at the bottom. The ultimate settlement in this condition will be

The settlement analysis for a clay layer draining from top and bottom shows a settlement of 2.5cm in 4 years and an ultimate settlement of 10cm.However detailed subsurface investigation reveals that there is no drainage at the bottom. The ultimate settlement in this condition will be?

In a cohesionless soil, the settlement of a 30 cm plate in a plate load test is 2cm, then the settlement of square footing of 90cm side under the same load intensity will be

In a cohesive soil, the settlement of a 30cm plate in a plate load test is 2cm, then the settlement of a square footing of 90 cm side under the same load intensity will be

Top Courses for Civil Engineering (CE)View all

General Aptitude for GATE

GATE Civil Engineering (CE) 2025 Mock Test Series

Fluid Mechanics for Civil Engineering

General Awareness & Knowledge

Topicwise Question Bank for Civil Engineering

Top Courses for Civil Engineering (CE)

Top Courses for Civil Engineering (CE)

Suggested Free Tests

Related Content

Mock Test Series

Subject-wise Courses

Subject-wise Courses

Other Engg Branches

Company