92 AutoDesk Inventor Assembly Tutorial: Insert Constraint Video Lecture | Autodesk Inventor: A Complete Learning - Design Softwares

this story we don't talk about the next
type of constrain the insect constraint
and it is the last type in the
constraint menu we already covered amid
anger tangent and the last one
insert not it's called concentric
relation and other software so let's
click on the insert as you see in the
picture it can make opposite direction
or inside that cylinder so it creates
intrical relations so now if you choose
the cylinder you'll notice that X is
shown and have done this sooner have
access if you select that part and that
part you don't get to just select this
cylinder and this cylinder you get
concentric relation to induce two and if
you make the opposite you will make them
the line so make use it and here we are
able to add offset but I don't want to
make this constraint now so just
consider so let's move into position
here now we are going to make concentric
relation between the connector and the
holes so constrain insert select is so
diverse direction
again line doesn't need to close that
mean you know I not the last connector
now we have all the connector in the
place so now we need only two constraint
to make this simply fully defined
so let's support the constraint make
this answer green this one of the hole
here so you have
that connector in place like so as you
notice here this part is rotating
Freddie around that selected connector
so you have an option to the last
constraint you can try the tangent and
also the insert let's try to insert
click this return to sender apply so now
you have your part is fully constrain
concept and try the tangent as well
cancel it this part this part next
inside tangent ok so now you have your
part fully defined